User Guide

ManualsBrandsKidde ManualsCarbon Monoxide and Smoke Detectorsi9010 Lithium Battery Operated Ionization Power Smoke Alarm

For your convenience, write down the following

information. If you call our Consumer Hotline,

these are the first questions you will be asked.

Lithium (non-replaceable sealed in) Battery-Operated

Smoke Alarm with Alarm Memory and SMART HUSH

Control to temporarily silence nuisance alarms.

Thank you for purchasing this smoke alarm. It is an important

part of your family’s home safety plan. You can trust this

product to provide the highest quality safety protection. We

know you expect nothing less when the lives of your family

are at stake.

Smoke Alarm User Guide

Date Code (located on back of alarm):

The National Fire Protection Association

(NFPA) and the manufacturer

recommend replacing this alarm

ten years from the date code.

Date of Purchase:

Where Purchased:

User Guide P/N 21008311-EN Rev. B

0910-7225-01

i9010

For model: i9010

0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 9:46 AM

Summary of content (16 pages)

PAGE 1
0910-7225-01(21008311B)_EN_V7.qxd:_ i9010 2016.12.14 For model: i9010 Smoke Alarm User Guide Lithium (non-replaceable sealed in) Battery-Operated Smoke Alarm with Alarm Memory and SMART HUSHTM Control to temporarily silence nuisance alarms. Thank you for purchasing this smoke alarm. It is an important part of your family’s home safety plan. You can trust this product to provide the highest quality safety protection. We know you expect nothing less when the lives of your family are at stake.
PAGE 2
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 This alarm detects products of combustion using the ionization technique. It contains 0.9 microcurie of Americium 241, a radioactive material (see Section 9). Distributed under U.S. NRC License No. 32-23858-01E. Manufactured in compliance with U.S. NRC safety criteria in 10 CFR 32.27. The purchaser is exempt from any regulatory requirements. Do not try to repair the smoke alarm yourself. Refer to the instructions in Section 12 for service.
PAGE 3
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 • The closed door may prevent an alarm not located in that room from waking the sleeper. • Smoke, heat, and combustion products rise to the ceiling and spread horizontally. Mounting the smoke alarm on the ceiling in the center of the room places it closest to all points in the room. Ceiling mounting is preferred in ordinary residential construction.
PAGE 4
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 • NFPA 72 states: “Smoke alarms in rooms with ceiling slopes greater than 1 ft in 8 ft (.3m in 2.4 m) horizontally shall be located on the high side of the room.” NFPA 72 states: “A row of detectors shall be spaced and located within 3 ft (0.9m) of the peak of the ceiling measured horizontally.” MOBILE HOME INSTALLATION Modern mobile homes have been designed and built to be energy efficient. Install smoke alarms as recommended above (see figures 1 and 2).
PAGE 5
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 • Smoke alarms should not be installed within 3 ft (.9m) of the following: the door to a kitchen, the door to a bathroom containing a tub or shower, forced air supply ducts used for heating or cooling, ceiling or whole house ventilating fans, or other high air flow areas. • Kitchens. Normal cooking may cause nuisance alarms. If a kitchen alarm is desired, it should have an alarm silence feature or be a photoelectric type. • Near fluorescent lights.
PAGE 6
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 2.After selecting the proper smoke alarm location as described in Section 1, attach the mounting bracket to the ceiling as shown in figure 3. For wall mounting see figure 4. Place the mounting plate on the wall; be sure the “A” line is horizontal (parallel to the floor). Use the screws and anchors provided to secure the mounting bracket (use 3/16” drill bit for anchors). 3.
PAGE 7
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 is allowed to engage the mounting bracket. Rotate the alarm onto the mounting bracket until you hear the tamper resist tab snap into place, locking the alarm on the mounting bracket. Using the tamper resist feature will help deter children and others from removing the alarm from the bracket.
PAGE 8
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 ! CAUTION: BEFORE USING THE ALARM SMART HUSHTM FEATURE, IDENTIFY THE SOURCE OF THE SMOKE AND BE CERTAIN A SAFE CONDITION EXISTS. FLASHING LED LIGHT: This smoke alarm is equipped with a flashing red indicator light with four modes of operation: • The LED will flash every 40-45 seconds in the standby mode signifying that the alarm is receiving power. • The LED will flash every 1.5 seconds when the alarm is sounding.
PAGE 9
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 5. NUISANCE ALARMS Smoke alarms are designed to minimize nuisance alarms. Cigarette smoke will not normally set off the alarm, unless the smoke is blown directly into the alarm. Combustion particles from cooking may set off the alarm if the alarm is located close to the cooking area. Large quantities of combustible particles are generated from spills or when broiling.
PAGE 10
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 7. PERMANENTLY DISABLE ALARM / DISCHARGE BATTERY ! WARNING! • Discharging the battery is permanent. Once the alarm has been discharged, it cannot be reactivated! • Once discharged , the alarm will NO LONGER DETECT SMOKE. • Once the alarm is discharged the battery will be depleted and the alarm will no longer function. • Once the alarm has been discharged, it cannot be mount- ed onto the mounting plate or reactivated.
PAGE 11
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 8. MAINTENANCE CLEANING YOUR ALARM YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR If the tamper resist feature has been activated you will need to follow the instructions in Section 3 to remove your alarm for maintenance. To clean your alarm, remove it from the mounting bracket as outlined in the beginning of this section.
PAGE 12
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 • AC powered alarms (without battery backup) will not operate if the AC power has been cut off, such as by an electrical fire or an open fuse. • Smoke alarms must be tested regularly to make sure the batteries and the alarm circuits are in good operating condition. • Smoke alarms cannot provide an alarm if smoke does not reach the alarm.
PAGE 13
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 when it sounds. They must wake up in order to execute the escape plan. Practice allows all occupants to test your plan before an emergency. You may not be able to reach your children. It is important they know what to do.
PAGE 14
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 11. NRC INFORMATION Ionization type smoke alarms use a very small amount of a radioactive element in the sensing chamber to enable detection of visible and invisible combustion products. The radioactive element is safely contained in the chamber and requires no adjustments or maintenance. This smoke alarm meets or exceeds all government standards. It is manufactured and distributed under license from the U.S. Nuclear Regulatory Commission. 12.
PAGE 15
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 This equipment should be installed in accordance with the National Fire Protection Association’s Standard 72 (NFPA, Batterymarch Park, Quincy, MA 02269). NOTIFY YOUR LOCAL FIRE DEPARTMENT AND INSURANCE COMPANY OF YOUR SMOKE ALARM INSTALLATION. 13. ! CAUTION (AS REQUIRED BY THE CALIFORNIA STATE FIRE MARSHAL) “Early warning fire detection is best achieved by the installation of fire detection equipment in all rooms and areas of the household as follows.
PAGE 16
0910-7225-01(21008311B)_EN_V7.qxd:_ 2016.12.14 TEN YEAR LIMITED WARRANTY KIDDE Safety warrants to the original purchaser that the enclosed smoke alarm will be free from defects in material and workmanship or design under normal use and service for a period of ten years from the date of purchase.