Installation Guide

ATTACHING AND ACTIVATING THE ALARM
This model is equipped with a feature that automatically activates the alarm
when the alarm is attached to the mounting plate for the first time. Once
activated, the battery will supply power to the alarm for the life of the alarm
(10 years) under normal conditions.
Align the alarm with the mounting plate and rotate clockwise (right) a
pproximately 45° until the unit stops and clicks into place. If unit needs to be
re-aligned, rotate the alarm counter clockwise, remove and rotate to desired
alignment. NOTE: The alarm will mount to the plate in three (3) positions (every
120 degrees).
You will know power has been supplied when alarm briefly chirps. Unit will
remain on until unit is disabled by the user at alarm’s end of life.
The alarm is now activated! After installation/activation, test your alarm
as described in Operation and Testing section.
Warning: Failure to properly install and activate this alarm
will prevent proper operation of this alarm and will prevent
its response to fire hazards.