Use and Care Manual

ManualsBrandsKidde ManualsElectrical10-Year Battery Powered Combination Smoke and Carbon Monoxide Detector with Alarm LED Warning Lights

recommend speciﬁc locations for smoke alarms, such as every level and

sleeping area of the dwelling. They also recommend a CO alarm be installed

on each level of the home—ideally on any level with fuel-burning appliances

and outside of sleeping areas. The alarm can be installed on the surface

of any wall or ceiling following the UL/NFPA/Manufacturer’s recommended

placement guidelines. See User Guide for more location information and

additional instructions.

Architectural & Engineering Speciﬁcations

WARNING: This product is intended for use in indoor residential locations. It is not

designed to measure compliance with Occupational Safety and Health Administration

(OSHA) commercial or industrial standards.

This device is designed to help protect individuals from acute eects of

Carbon Monoxide exposure. It will not fully safeguard individuals with

speciﬁc medical conditions. If in doubt, consult a medical practitioner.

Individuals with medical problems may consider using warning devices

which provide audible and visual signals for carbon monoxide concentrations

under 30 ppm.

CO alarm response times:

70 ppm: 60-240min

150 ppm: 10-50min

400 ppm: 4-15min

The alarm shall include a test button that will electronically simulate the

presence of smoke and CO and cause the unit to go into both modes of

alarm. This sequence tests the unit’s electronics to ensure proper operation.

The unit shall incorporate three LED colors. A green LED will ﬂash every

60 seconds when in standby condition. An amber LED will indicate fault

conditions. A red LED will ﬂash in sync with the smoke alarm pattern, and will

also indicate alarm memory.

The unit shall include the Hush™ feature that silences a smoke alarm

for approximately 8-10 minutes if a nuisance alarm condition occurs. The

red LED on the alarm will ﬂash every 2 seconds while in Hush and will

automatically reset itself.

At the date of manufacture, the unit shall at a minimum meet the

requirements of UL 217, UL 2034, NFPA 72, NFPA 101 (One and two family

dwellings), Federal Housing Authority (FHA), and Housing and Urban

Development (HUD).

Technical Speciﬁcations

Model: 30CUD10

Power Source: 10-year† sealed battery operated

Smoke Sensor: Photoelectric

CO Sensor: Electrochemical

Audio Alarm: 85dB at 10ft

Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)

Humidity Range: 10 to 95% relative humidity (RH), non-condensing

Size: 5” W x 2” D x 5” H

Weight: 0.79 lb

Wiring: N/A

Interconnects: N/A

Warranty: 10-Year Limited Warranty (battery included)

Replacement Batteries: N/A

Ordering Information

Ordering

Number UPC GTIN Pack Conﬁg. Pack Qty

Case Dimensions

(D x W x H inches) Case Weight (lbs) Cartons/Pallet

21031514 047871315147 – Box – – – –

21031516 047871315161 – Box – – – –

21031517 047871315178 – Box – – – –

21032839 047871328390 – Box – – – –

21032840 047871328406 – Box – – – –

SMOKE + CARBON MONOXIDE ALARM | DETECT SERIES | MODEL 30CUD10

1016 Corporate Park Drive, Mebane, NC 273021-800-880-6788Kidde.com