Brochure

Part Number UPC Pack Quantity Dimensions (w x d x h) I 2 of 5 Weight Items/Skid
21010047 0-47871-10045-3 3-PK (clam) 8 x 9.5 x 11.5 100-47871-10045-0 1.35 lb. 225
21010075 0-47871-10075-0 6-PK (box) 6.25 x 10.75 x 4.25 100-47871-10075-7
6.00 lbs. 1296
2.75”
Technical Specifications
Power Source: Sealed Lithium Battery
Sensor: Electrochemical
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
Humidity Range: 10%-95% relative humidity (RH)
Size: 4.5”L x 2.75”H x 1.5” D
Weight: .31lb
Wiring: No
Interconnects: No
Warranty: 10 year limited
Sealed Battery Carbon Monoxide Alarm
with Digital Display
Model C3010-D
Ordering Information
1016 Corporate Park Drive
Mebane NC 27302
1-800-880-6788
www.Kidde.com
KL-C3010-D sheet rev. 11-2012
Distributed by:
4.5” 1.5”
Architectural and Engineering
Specifications
The carbon monoxide alarm shall be Kidde Model C3010-D or
approved equal. It shall be powered by a sealed lithium battery. The
temperature operating range shall be between 40ºF and 100ºF (4ºC
and 38ºC) and the humidity operating range shall be 10% - 95% non
condensing relative humidity.
The CO sensor shall be of a fuel cell design and shall meet the sen-
sitivity requirements of Underwriters Laboratories UL2034 Single and
Multiple Station Carbon Monoxide Alarms.
The alarm can be installed on the surface of any wall or placed on a
tabletop following the UL/NFPA/Manufacturer’s recommended place-
ment guidelines.
The unit shall incorporate a digital display that meets the sensitivity
requirements of UL 2034. The display will identify the levels of CO in
parts per million (PPM) once that level reaches 30 PPM (i.e.: “abnor-
mal” levels).
The alarm shall include a test button that will electronically simu-
late the presence of CO and cause the unit to go into alarm. This
sequence tests the unit’s electronics to ensure proper operation.
Per UL 2034 requirements, the CO sensor will not alarm to levels of
CO below 30 ppm and will alarm in the following time range when
exposed to the corresponding levels of CO.
70 ppm CO Concentration 60 – 240 minutes
150 ppm CO Concentration 10 – 50 minutes
400 ppm CO Concentration 4 – 15 minutes
The unit shall incorporate 3 LEDs. A green LED will flash once every
30 seconds to indicate the alarm is operating properly when power is
present. A red LED will pulse to indicate carbon monoxide has been
detected until the device is reset or CO is eliminated. An amber LED
will flash every second to signal alarm malfunction or low battery.
The alarm shall include a piezoelectric horn that is rated at 85 deci-
bels at 10 feet. When the unit detects carbon monoxide, the alarm
pattern will be four (4) short beeps – followed by five (5) seconds of
silence – followed by four (4) short beeps with a corresponding red
LED flash.
It shall include a 10-year manufacturer’s limited warranty.