Operation Manual

9
ENG
4.2 Installation facing backwards
After you have consulted the operating handbook for the vehicle, you can
install the kiddy nest on the appropriate seat (see 4.1) as follows:
Fig 1. - Make sure that the kiddy nest faces backwards on the car seat
(please observe the instructions in section 4.1) and place the
holder in the position for driving (see 3.1).
Fig 2. - Slide the lap belt of the vehicle’s 3 - point seatbelt through both
pelvic guides. Let the tongue plate snap in the belt lock with a
clearly audible “click”. Check to make sure it is locked by pulling
on the belt.
Fig 3. - Now slide the shoulder belt of the vehicle’s own 3-point seatbelt
around the back of the kiddy nest’s headrest. Insert the shoulder
strap in the guide intended for it on the kiddy nest.
Fig. 1 Fig. 2
Fig. 3 Fig. 4