Instructions / Assembly

1 x SW Wall Panel 1-1/4 x 37 x 92”
1 x Front Wall Panel 1-1/4 x 43 x 92”
1 x Back Wall Panel 1-1/4 x 43 x 92”
Wood Parts
050
Step 5: Swing Wall Assembly
A: Place (051) Front Wall Panel against the left side of (050) SW Wall Panel noticing panel orientation. The tops
and bottoms of the panels should be ush and panels square. Pre-drill with a 3/16” drill bit, then fasten (051)
Front Wall Panel to (050) SW Wall Panel with 4 (WL5) 1/4 x 2-1/2” Wafer Lags. (g. 5.1 and 5.2)
B: Place (052) Back Wall Panel against the right side of (050) SW Wall Panel noticing panel orientation. The
tops and bottoms of the panels should be ush and panels square. Pre-drill with a 3/16” drill bit, then fasten
(050) SW Wall Panel to (052) Back Wall Panel to with 4 (WL5) 1/4 x 2-1/2” Wafer Lags. (g. 5.1 and 5.3)
Fig. 5.2
052
Fig. 5.1
050
Flush
Hardware
8 x 1/4 x 2-1/2” Wafer Lag
WL5
Flush
051
052
Notice (051) Front Wall
Panel overlaps (050)
SW Wall Panel
Fig. 5.3
050
050
Notice (050) SW Wall
Panel overlaps (052)
Back Wall Panel
WL5
WL5
051
25 [e-mail]