User Manual

BATTERY AND ANTENNA INSTALLATION FOR TRANSMITTER
To operate your transmitter you will need 1 x 9 Volt battery
(not included).
NOTE: for best performance, use of alkaline batteries is recommended.
1. Unscrew battery cover as show and remove battery cover.
2. Install 1 new 9V battery. Close battery cover and tighten the screw on battery cover.
3. Move the power button to the " I "(ON) position and the red LED light will come on.
This will show you that the battery is good and the transmitter is ready for operation.
PLEASE NOTE: Vehicle power switch must be in the " I " (ON) position to receive
commands from the transmitter.
4. Change batteries when LED is dim or not on.
5. Insert the antenna into the top of transmitter, tighten it by rotating clockwise(viewing from
top of transmitter).