Operator Manual Owner manual
T23_AA_Operator Manual_2014 Revised 08/2014
Start Up & Operaon
Select the proper turbine/gearbox v-belt pulley and gearbox range combinaon. Cauon! Always
make sure the Turbine is stopped before making any changes to the turbine and gearbox pulley
sengs.
Turbine Speed Sengs:
Refer to the speed range chart for correct selecon by ulizing the following steps:
1. Select the proper speed range from the “Turbine Drive Speed Range” chart.
2. Veriy the turbine is stopped & select the desired turbine and gearbox pulley seng based on desired
speed of retracon (/hr).
Cauon! Never aempt to change pulley sengs when the gearbox is under load. Serious damage
could occur to the gearbox. See page 12 for instrucons on how
to remove the load so that gearbox seng changes can be
made.
Turbine Drive Speed Ranges
(Approximate)
Changing Pulley Sengs:
If you need to change the pulley sengs, make certain the turbine is
stopped and perform the following steps:
1. Loosen the bolt holding the gearbox in place (See Photo 1 below).
2. Move the gearbox by pushing it forward as shown in Photo 2. This
will take tension o the belt and allow you to make the appropriate
pulley change.
3. Once the belt is on the correct pulley seng, pull the gearbox back
into posion and ghten the bolt.
Photo 1
Photo 2
22