SDS

8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Table Z-3 (29 CFR 1910.1000)
ValueComponents Type
TWA 0.8 mg/m3Diatomaceous earth (CAS
61790-53-2)
20 mppcf
US. ACGIH Threshold Limit Values
Form
ValueComponents Type
STEL 10 mg/m3 Aerosol, inhalable.Ethylene glycol (CAS
107-21-1)
50 ppm Vapor fraction
TWA 25 ppm Vapor fraction
US. NIOSH: Pocket Guide to Chemical Hazards
ValueComponents Type
TWA 6 mg/m3Diatomaceous earth (CAS
61790-53-2)
US. Workplace Environmental Exposure Level (WEEL) Guides
ValueComponents Type
TWA 0.5 mg/m3Diphenyl ketone (CAS
119-61-9)
No biological exposure limits noted for the ingredient(s).
Biological limit values
Good general ventilation should be used. Ventilation rates should be matched to conditions. If
applicable, use process enclosures, local exhaust ventilation, or other engineering controls to
maintain airborne levels below recommended exposure limits. If exposure limits have not been
established, maintain airborne levels to an acceptable level.
Appropriate engineering
controls
Individual protection measures, such as personal protective equipment
Wear safety glasses with side shields (or goggles).
Eye/face protection
Skin protection
Wear appropriate chemical resistant gloves.
Hand protection
Skin protection
Use of an impervious apron is recommended.
Other
If airborne concentrations are above the applicable exposure limits, use NIOSH approved
respiratory protection. Use a positive-pressure air-supplied respirator if there is any potential for an
uncontrolled release, exposure levels are not known, or any other circumstances where
air-purifying respirators may not provide adequate protection.
Respiratory protection
Wear appropriate thermal protective clothing, when necessary.
Thermal hazards
Observe any medical surveillance requirements. Always observe good personal hygiene
measures, such as washing after handling the material and before eating, drinking, and/or
smoking. Routinely wash work clothing and protective equipment to remove contaminants.
General hygiene
considerations
9. Physical and chemical properties
Appearance
Liquid.
Physical state
Liquid.
Form
Opaque.
Color
Slight.
Odor
Odor threshold
Not available.
pH
7 - 10
Melting point/freezing point
Not available.
Initial boiling point and boiling
range
> 99 °F (> 37.2 °C)
KILZ® Klear Interior/Exterior Clear Sealer & Bonding Primer SDS US
954082 Version #: 01 Revision date: - Issue date: 05-June-2020
3 / 7