Use and Care Manual

!
Depending on the surface texture, porosity and application method.
!!
At 77°F (25°C), 50% RH. Longer dry time may be required in cooler temperatures and in
higher humidity.
Soap & Water
Clean-Up
300 - 400 sq. ft. / gal.
!
30 Min - Dry Time to Touch
!!
1 Hr - Dry Time to Recoat
!!
Protect from
Freezing
KILZ RESTORATION
™
INTERIOR WATER-BASE OIL & SHELLAC SUBSTITUTE PRIMER
• New technology water base primer/sealer/stain blocker
• For use with interior surfaces
• Maximum performance stain and odor blocker
• Formulated to perform like oil and shellac based products
• Tackles tough stains including medium-to-heavy water damage,
rust, smoke, nicotine, grease, tannin, ink, pet stains and more
WHERE TO USE
KILZ RESTORATION
™
is a new generation water-based primer, sealer and stain
blocker offering performance of traditional oil and shellac-based primers. It
tackles tough stains including severe water damage, rust, smoke, nicotine, grease,
tannin, ink, pencil, felt marker, pet stains and more. KILZ RESTORATION also seals
persistent pet, food and smoke odors. Use on interior surfaces including drywall,
woodwork, plaster, masonry, brick, painted metal, ceramic tile, glass and most other
glossy surfaces
†
. Topcoat with latex or oil-based paint. Use to block odors from
suboor when replacing carpet or wood ooring.
SURFACE PREPARATION (The following steps are recommended for product
performance)
• All surfaces must be clean, free of dust, chalk, oil, grease, wax, polish, mold and
mildew, loose peeling paint, rust and all other foreign substances.
• If washing is necessary, use a non-soapy detergent or a TSP substitute, rinse
well and allow to dry.
• Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface.
Sanding or removal of paint containing lead is hazardous
*
.
•
†
Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly
before priming
*
.
• Mold or Mildew Covered Surfaces: Wash the area with a mildew remover, rinse
with water and allow to dry before priming.
• Masonry, Brick, Stucco and Plaster: KILZ RESTORATION primer may be used on
clean, dry, aged interior masonry surfaces that have cured (dried) at least 30
days.
• Fire Restoration: It is critical to clean damaged surfaces thoroughly
before priming.
*
WARNING If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC.
Contact the National Lead Information Center at 1-800-424-LEAD or log on to www.epa.gov/lead.
APPLICATION
• Eye protection is recommended. For spray applications, a small amount of
water (no more than 1/2 pint per gallon) may be added. Do not thin for stain
blocking applications.
• Only apply if surface, air and product temperatures are between 50°-90°F.
Stir thoroughly before and occasionally during use. Apply using a brush,
roller or sprayer.
• Brush – High quality Nylon/Polyester
• Roller – High quality 3/8-1/2” nap on smooth surfaces or 1/2-3/4” nap on
semi-rough or porous surfaces.
• Airless spray – .017 - .021 tip / 60 mesh lter
• Prime the entire surface to ensure a uniform appearance of the topcoat.
• Stain blocking: After priming, test for stain bleed-through by applying the
topcoat to a small section. If the stain bleeds through the topcoat, apply a
second coat of primer and test again before topcoating the entire area. If
bleeding continues, a longer dry time is needed before topcoating.
CLEAN-UP & DISPOSAL
• Clean equipment and paint spatters with warm, soapy water.
• Do not dispose of this product down a drain.
• Please consider donating any unused product.
• For recycling or disposal information contact your local household refuse
collection service.
• If spilled, contain material and remove with an inert absorbent. Dispose of
contaminated absorbent, container and unused product in accordance with all
current local, state and federal regulations.
WARNING
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
USE ONLY WITH ADEQUATE VENTILATION
CAUTION IRRITANT Avoid contact with eyes. May cause eye, nose and throat irritation. Avoid breathing of dust,
vapors or spray mist. Open windows and doors or use other means to ensure fresh air entry during application and drying.
If you experience eye watering, headache or dizziness or if air monitoring demonstrates vapor/ mist levels are above
applicable limits, wear an appropriate, properly tted respirator (NIOSH / MSHA TC -23C or equivalent) during and after
application. Follow respirator manufacturer’s directions for respirator use. Close container after each use. Wash thoroughly
after handling and before smoking or eating. FIRST AID: If swallowed, do not induce vomiting. Get medical attention
immediately. If you experience difculty in breathing, leave the area to obtain fresh air. If continued difculty is experienced,
get medical attention immediately. In case of eye contact, ush eyes immediately with plenty of water for at least 15 minutes
and get medical attention.
KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY
LIFETIME LIMITED WARRANTY: Masterchem Industries LLC warrants to you, the original residential consumer purchaser, the
performance of this product as described on this label for so long as you reside in your home. If this product is found to be defective upon
inspection by its representative, Masterchem Industries LLC will, at its option and upon presentation of proof-of-purchase (the original receipt),
either furnish an equivalent amount of new product or refund the original purchase price of this product to you. This warranty is not transferable.
This warranty excludes (1) labor and costs of labor for the application or removal of any product, and (2) any incidental or
consequential damages, whether based on breach of express or implied warranty, negligence, strict liability or any other legal
theory. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you. To the extent permitted by applicable law, any implied warranties including the implied warranties of merchantability and of
tness for a particular purpose, are limited to the duration of this express warranty. Some states do not allow limitations on how long an implied
warranty lasts, so the above limitation may not apply to you. This warranty gives you specic legal rights and you may also have other rights,
which vary from state to state. Note to residents of the State of New Jersey: The provisions of this warranty, including its limitations,
are intended to apply to the fullest extent permitted by the laws of the State of New Jersey. For warranty service, call: 1-866-774-6371, or
email: [e-mail]. Masterchem Industries LLC reserves the right to inspect any and all application of the product prior to
processing your claim made under this warranty.
©2019 Masterchem Industries LLC
1-866-774-6371 • www.kilz.com
L2002 • REV. 06/19
RESTORATION VOC: <100 Grams/Liter (<0.83
Pounds/Gallon)
• Sealing Odors: For persistent odors, apply a second coat of primer before
topcoating. If odor continues, a longer drytime is needed before topcoating.
• Tinting: KILZ RESTORATION primer may be tinted with up to 2 ounces of
universal colorant per gallon. Tinting to a lighter shade than the topcoat is
recommended.
• Coverage: 300 - 400 sq. ft. (27.87 - 37 m2) per gallon depending on application
method and surface porosity.
• Dry Time @ 77°F (25°C) / 50% RH: Touch 30 minutes, Recoat 1 hour.
• Ideal for disaster restoration and remediation jobs
• Excellent in sealing pet and smoke odors
• Fast drying, very mild odor
• Easy clean-up with soap and water
• Powerful odor blocker makes it ideal as a sub-coat for new ooring or carpet
• Low VOC (Volatile Organic Compounds)