TDS

TECHNICAL DATA SHEET
KILZ
®
UPSHOT
®
INTERIOR OVERHEAD STAIN SEALER
KILZ
®
Upshot
®
is a unique interior stain sealer that has a vertical spray tip for easy ceiling
application. It blocks most ceiling stains such as water, smoke, grease and more. KILZ Upshot
dries fast and is tinted to match most aged and acoustical ceilings.
WHERE TO USE
Use on properly prepared interior surfaces, such as:
This information is provided “as is” and no representations or warranties, either express or implied, of merchantability, fitness for a particular purpose or
of any other nature are made with respect to this information or to any product referred to in this information.
For MSDS or to consult with a technical service representative, call 1-866-PRIMER-1.
©2011 Masterchem Industries, 3135 Old Hwy M, Imperial, MO 63052-2834
1-866-PRIMER-1 • www.kilz.com
®
1 of 2
AS OF 6/1/2011 COMPLIES OR IS CERTIFIED WITH:
SCAQMD Yes MPI # No
CARB Yes MPI X-GREEN No
OTC Yes GREENGUARD No
LADCO Yes GREEN SEAL™ No
AIM Yes CHPS No
LEED
®
No NAHB / ICC NGBS No
• Brick
• Painted Metal
• Properly Prepared Glossy Surfaces†
• Drywall
• Paneling
• Wallpaper
• Masonry
• Plaster
• Wood
SHOT
®
FILL
No. 10007
Aerosol – 10 oz
FINISH
85° = < 10.0
Sheen levels depend on porosity and various surface
irregularities.
COMPOSITION
Vehicle: Modified Alkyd
Weight Solids: 40.0% (+/-) 2%
Volume Solids: 18.0% (+/-) 2%
Max VOC (by weight): 60%
Max Product Weighted MIR: 1.20
FLASHPOINT
-156°F (-104°C)
COVERAGE RATE
Coverage: 14 - 19 sq. ft. (1.3 - 1.7 m
2
) per
gallon, depending on the surface texture,
porosity and application method. Does not
include the loss of material from spraying.
SURFACE PREPARATION†
• The surface must be clean, free of dust, grease,
wax, peeling paint, mold, mildew and
wallpaper paste. If washing is necessary, use a
non-soapy detergent or a TSP substitute. Rinse
well and allow to dry.
• Peeling or Checked Paint: Scrape off loose
paint and sand to a smooth surface. Sanding
or removal of paint containing lead is
hazardous.†
• Glossy Surfaces: For maximum adhesion, scuff
sand the surface thoroughly before priming.†
APPLICATION
• Eye protection is recommended.
• For best results, use at room temperature.
• Cover adjacent areas to protect from
overspray.
• Shake can vigorously for 1 minute after
mixing ball begins to rattle and often
during use.
• Hold can upright, moving from side-to-side
while spraying lightly and evenly about 12”
from area being painted.
• Two to three thin coats produce best results.
• Topcoat with latex or oil-based paint.
• NOTE: On some surfaces, spot priming may
cause a non-uniform appearance in the final
coat. To avoid this, prime the entire surface.
DRY TIME at 77°F (25°C), 50% RH:
• To Touch: 15 - 30 Minutes
• To Recoat / Topcoat: 1 Hour
Longer dry time may be required in cooler temperatures
and in higher humidity.