TDS

TECHNICAL DATA SHEET
KILZ ODORLESS
®
INTERIOR AEROSOL PRIMER
KILZ Odorless
®
primer is a fast-drying stainblocking primer for use on most interior surfaces. Its
ultra low odor formula significantly reduces the lingering odors normally associated with oil-based
products, making it ideal to use in areas where higher odor levels are prohibitive. Any slight odor
detected during the application of KILZ Odorless primer will dissipate soon after drying.
WHERE TO USE
Use on properly prepared interior surfaces, such as:
This information is provided “as is” and no representations or warranties, either express or implied, of merchantability, fitness for a particular purpose or
of any other nature are made with respect to this information or to any product referred to in this information.
For MSDS or to consult with a technical service representative, call 1-866-PRIMER-1.
©2011 Masterchem Industries, 3135 Old Hwy M, Imperial, MO 63052-2834
1-866-PRIMER-1 • www.kilz.com
®
1 of 2
AS OF 6/1/2011 COMPLIES OR IS CERTIFIED WITH:
SCAQMD No MPI # No
CARB No MPI X-GREEN No
OTC No GREENGUARD No
LADCO No GREEN SEAL™ No
AIM No CHPS No
LEED
®
No NAHB / ICC NGBS No
• Brick
• Painted Metal
• Properly Prepared Glossy Surfaces†
• Drywall
• Paneling
• Wallpaper
• Masonry
• Plaster
• Wood
®
FILL
No. 1044
Aerosol – 13 oz
FINISH
85° = < 10.0
Sheen levels depend on porosity and various surface
irregularities.
COMPOSITION
Vehicle: Solution Acrylic
Weight Solids: 42.2% (+/-) 2%
Volume Solids: 16.5% (+/-) 2%
Max VOC (by weight): 60%
Max Product Weighted MIR: 1.20
FLASHPOINT
-156°F (-104°C)
COVERAGE RATE
Coverage: 20 - 25 sq. ft. (1.9 - 2.3 m
2
) per
container, depending on the surface texture,
porosity and application method. Does not
include the loss of material from spraying.
SURFACE PREPARATION†
• The surface must be clean, free of dust, grease,
wax, peeling paint, mold, mildew and
wallpaper paste. If washing is necessary, use a
non-soapy detergent or a TSP substitute. Rinse
well and allow to dry.
• Peeling or Checked Paint: Scrape off loose
paint and sand to a smooth surface. Sanding
or removal of paint containing lead is
hazardous.†
• Glossy Surfaces: For maximum adhesion, scuff
sand the surface thoroughly before priming.†
APPLICATION
• Eye protection is recommended.
• For best results, use at room temperature.
• Cover adjacent areas to protect from
overspray.
• Shake can vigorously for 1 minute after
mixing ball begins to rattle and often during
use.
• Hold can upright, moving from side-to-side
while spraying lightly and evenly about 12”
from area being painted.
• Two to three thin coats produce best results.
• Topcoat with latex or oil-based paint after 1
hour.
• NOTE: On some surfaces, spot priming may
cause a non-uniform appearance in the final
coat. To avoid this, prime the entire surface.
DRY TIME at 77°F (25°C), 50% RH:
• To Touch: 15 - 30 Minutes
• To Recoat / Topcoat: 1 Hour
Longer dry time may be required in cooler temperatures
and in higher humidity.