Use and Care Manual
Mineral Spirits
Clean-Up
20 - 25 Sq. Ft. (1.9 - 2.3 m
2
)
per container*
To Touch: 15 - 30 Minutes**
To Recoat / Topcoat: 1 Hour**
Protect from
Freezing
KILZ
®
ODORLESS
®
INTERIOR OIL-BASE PRIMER AEROSOL
• Oil based primer/sealer/stainblocker in convenient
aerosol spray
• Interior use
• Ideal for spot priming in areas sensitive to solvent odors
• Fast-dissipating odor technology for no lingering odors
• Blocks heavy stains including tannin bleed
WHERE TO USE
KILZ ODORLESS
®
Oil-base is a powerful interior stain blocker with no lingering odor.
Ideal for use in ofces, schools, dining areas, apartments and other areas sensitive to
strong solvent odors. Use KILZ ODORLESS to block stains including water, tannin and
smoke from tobacco and re. Not recommended for oors.
SURFACE PREPARATION
(The following steps are recommended for product
performance)
• The surface must be clean, free of dust, grease, wax, peeling paint, mold,
mildew, wallpaper paste. If washing is necessary, use a non-soapy detergent or
a TSP substitute. Rinse well and allow to dry.
• Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface.
Sanding or removal of paint containing lead is hazardous.
WARNING
If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC.
Contact the National Lead Information Center at 1-800-424-LEAD or log on to www.epa.gov/lead.
• Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly
before priming.
APPLICATION
• Eye protection is recommended.
• For best results, use at room temperature. Cover adjacent areas to protect
from overspray.
• Shake can vigorously for 1 minute after mixing ball begins to rattle and often
during use. Hold can upright, moving from side-to-side while spraying lightly
and evenly about 12” from area being painted. Two to three thin coats produce
best results.
• Topcoat with latex or oil-based paint after 60 minutes. NOTE: On some surfaces,
spot priming may cause a non-uniform appearance in the nal coat. To avoid
this, prime the entire surface.
CLEAN-UP & DISPOSAL
• Clear spray valve immediately after use by turning can upside down and
spraying until only clear gas is released. If spray nozzle becomes clogged,
remove and clean.
• Do not stick pins or wire into can opening.
• Replace nozzle with valve opening pointed away from you. Clean fresh
overspray with mineral spirits or acetone. Remove dried paint with paint
remover, but test small area rst to ensure paint remover does not damage
substrate.
• Please consider donating any unused product. For recycling or disposal
information contact your local household refuse collection service.
WARNING
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
LIMITED WARRANTY:
For warranty service, call: 1-866-774-6371, or email: techservice@
masterchem.com. Masterchem Industries LLC reserves the right to inspect any and all
application of the product prior to processing your claim made under this warranty.
• Seals persistent smoke, pet and food odors
• Lower solvent odor than typical oil based primers
• Ideal for priming drywall, brick, masonry, metal, plaster, siding and wood
• Fast drying - recoat in 1 hour
VENTILATION REQUIRED:
To avoid inhalation and combustion hazards (see below),
DO NOT
use this product unless you can achieve cross-ventilation by opening windows and
doors during application and drying.
CONTAINS PETROLEUM DISTILLATES AND ACETONE.
VAPOR HARMFUL.
May affect the brain or nervous system causing dizziness, headache or
nausea. Causes eye, skin, nose and throat irritation. Do not breathe vapors or spray mist.
If you experience eye watering, headaches or dizziness, increase fresh air, wear respira-
tory protection (NIOSH/MSHA TC-23C or equivalent) or leave the area.
NOTICE:
Reports
have associated repeated and prolonged occupational overexposure to solvents with
permanent brain and nervous system damage. Intentional misuse by deliberately con-
centrating and inhaling the contents may be harmful or fatal.
VAPORS MAY IGNITE EXPLO-
SIVELY.
Do not spray near sparks, heat or open ame. Do not smoke. Vapors are heavier
than air, and can travel at oor level to distant ignition sources. Extinguish all ames and
pilot lights and turn off stoves, heaters, electric motors, high intensity lights and other
sources of ignition during use and until all vapors are gone.
WARNING-CONTENTS UNDER
PRESSURE:
Do not puncture or incinerate container. Do not expose to heat or store at tem-
peratures above 120ºF. Prolonged exposure to sun may cause bursting.
FIRST AID:
If you
have difculty breathing, leave area to obtain fresh air. If difculty continues, get medical
attention immediately. In case of eye contact, ush immediately with plenty of water for
at least 15 minutes and get medical attention. For skin contact, wash thoroughly with
soap and water.
KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY
* Depending on the surface texture, porosity and application method.
**At 77°F (25°C), 50% RH. Longer dry time may be required in cooler temperatures
and in higher humidity.
Max VOC: 60% By Weight
Max Product Weighted MIR: 0.7
©2018 Masterchem Industries LLC
1-866-774-6371 • www.kilz.com
REV. 07/18 • 10444