SDS

ManualsBrandsKILZ ManualsPaint13 oz. Mold & Mildew White Oil-Based Interior and Exterior Primer, Sealer and Stain-Blocker Aerosol

SAFETY DATA SHEET

1. Identification

Product identifier

Other means of identification

Product number

Recommended use

KILZ® Mold & Mildew Interior/Exterior Primer - Aerosol

L204644

Architectural Coating

None known.

Recommended restrictions

Manufacturer/Importer/Supplier/Distributor information

Masterchem Industries LLC

Supplier

3135 Old Highway M

Imperial, MO 63052-2834

636-942-2510

Telephone

+1 760 476 3962

Emergency telephone

+1 866 519 4752

335213

Access code

2. Hazard(s) identification

Category 1Flammable aerosols

Physical hazards

Compressed gasGases under pressure

Category 2Skin corrosion/irritation

Health hazards

Category 2ASerious eye damage/eye irritation

Category 1Sensitization, skin

Category 2Reproductive toxicity

Category 3 narcotic effectsSpecific target organ toxicity, single exposure

Not classified.

OSHA defined hazards

Label elements

Signal word

Danger

Hazard statement

Extremely flammable aerosol. Contains gas under pressure; may explode if heated. Causes skin

irritation. May cause an allergic skin reaction. Causes serious eye irritation. May cause

drowsiness or dizziness. Suspected of damaging fertility or the unborn child.

Precautionary statement

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read

and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not

spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn,

even after use. Avoid breathing mist/vapors. Wash thoroughly after handling. Use only outdoors

or in a well-ventilated area. Contaminated work clothing must not be allowed out of the workplace.

Wear protective gloves/protective clothing/eye protection/face protection.

Response

If on skin: Wash with plenty of water. If skin irritation or rash occurs: Get medical advice/attention.

If inhaled: Remove person to fresh air and keep comfortable for breathing. If in eyes: Rinse

cautiously with water for several minutes. Remove contact lenses, if present and easy to do.

Continue rinsing. If eye irritation persists: Get medical advice/attention. If exposed or concerned:

Get medical advice/attention. Take off contaminated clothing and wash it before reuse.

Storage

Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from

sunlight. Store in a well-ventilated place. Do not expose to temperatures exceeding 50°C/122°F.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations.

Hazard(s) not otherwise

classified (HNOC)

None known.

KILZ® Mold & Mildew Interior/Exterior Primer - Aerosol SDS US

Version #: 0.1 Revision date: 21-August-2020 Issue date: 21-August-2020

1 / 10

Summary of content (10 pages)

PAGE 1
SAFETY DATA SHEET 1. Identification Product identifier Other means of identification Product number KILZ® Mold & Mildew Interior/Exterior Primer - Aerosol Recommended use L204644 Architectural Coating Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Supplier Telephone Emergency telephone Access code Masterchem Industries LLC 3135 Old Highway M Imperial, MO 63052-2834 636-942-2510 +1 760 476 3962 +1 866 519 4752 335213 2.
PAGE 2
Supplemental information None. 3. Composition/information on ingredients Mixtures Chemical name CAS number % 67-64-1 10 - 30 Distillates (petroleum), hydrotreated light 64742-47-8 10 - 30 Naphtha (petroleum), hydrotreated light 64742-49-0 7 - 13 Titanium dioxide 13463-67-7 7 - 13 Limestone 1317-65-3 5 - 10 Talc 14807-96-6 5 - 10 2-ethylhexanoic Acid, Zirconium Salt 22464-99-9 0.1 - 1 123-26-2 0.
PAGE 3
Fire fighting equipment/instructions Specific methods General fire hazards In case of fire: Stop leak if safe to do so. Do not move cargo or vehicle if cargo has been exposed to heat. Move containers from fire area if you can do so without risk. Cool containers exposed to heat with water spray and remove container, if no risk is involved. Containers should be cooled with water to prevent vapor pressure build up. For massive fire in cargo area, use unmanned hose holder or monitor nozzles, if possible.
PAGE 4
US. OSHA Table Z-3 (29 CFR 1910.1000) Components Type Talc (CAS 14807-96-6) TWA Value Form 0.1 mg/m3 Respirable. 20 mppcf Titanium dioxide (CAS 13463-67-7) 2.4 mppcf Respirable. 5 mg/m3 Respirable fraction. 15 mg/m3 Total dust. 50 mppcf Total dust. 15 mppcf Respirable fraction. Type Value Form STEL 10 mg/m3 TWA US.
PAGE 5
Skin protection Other Wear appropriate chemical resistant clothing. Respiratory protection If airborne concentrations are above the applicable exposure limits, use NIOSH approved respiratory protection. Chemical respirator with organic vapor cartridge and full facepiece. Use a positive-pressure air-supplied respirator if there is any potential for an uncontrolled release, exposure levels are not known, or any other circumstances where air-purifying respirators may not provide adequate protection.
PAGE 6
Incompatible materials Strong oxidizing agents. Hazardous decomposition products No hazardous decomposition products are known. 11. Toxicological information Information on likely routes of exposure May cause drowsiness and dizziness. Prolonged inhalation may be harmful. Inhalation Skin contact Causes skin irritation. May cause an allergic skin reaction. Eye contact Causes serious eye irritation. Ingestion Expected to be a low ingestion hazard.
PAGE 7
IARC Monographs. Overall Evaluation of Carcinogenicity Talc (CAS 14807-96-6) 2B Possibly carcinogenic to humans. 3 Not classifiable as to carcinogenicity to humans. Titanium dioxide (CAS 13463-67-7) 2B Possibly carcinogenic to humans. NTP Report on Carcinogens Not listed. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1053) Not listed. Suspected of damaging fertility or the unborn child. Reproductive toxicity Specific target organ toxicity single exposure May cause drowsiness and dizziness.
PAGE 8
Transport hazard class(es) Class Subsidiary risk Packing group Environmental hazards ERG Code Special precautions for user IMDG UN number UN proper shipping name Transport hazard class(es) Class Subsidiary risk Packing group Environmental hazards Marine pollutant EmS Special precautions for user Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code 2.1 Yes 10L Read safety instructions, SDS and emergency procedures before handling. UN1950 Aerosols, flammable 2.
PAGE 9
Drug Enforcement Administration (DEA). List 2, Essential Chemicals (21 CFR 1310.02(b) and 1310.04(f)(2) and Chemical Code Number Acetone (CAS 67-64-1) 6532 Drug Enforcement Administration (DEA). List 1 & 2 Exempt Chemical Mixtures (21 CFR 1310.12(c)) Acetone (CAS 67-64-1) 35 %WV DEA Exempt Chemical Mixtures Code Number Acetone (CAS 67-64-1) 6532 FEMA Priority Substances Respiratory Health and Safety in the Flavor Manufacturing Workplace Acetone (CAS 67-64-1) Low priority US state regulations US.
PAGE 10
Disclaimer Masterchem Industries LLC cannot anticipate all conditions under which this information and its product, or the products of other manufacturers in combination with its product, may be used. It is the user’s responsibility to ensure safe conditions for handling, storage and disposal of the product, and to assume liability for loss, injury, damage or expense due to improper use. The information in the sheet was written based on the best knowledge and experience currently available.