Owner Manual

Wood Surface Care
Fabric Cleaning and Care
• Clean laminate surfaces with a mild soap and water solution.
Wipe the surface, moving with the grain on laminate surfaces.
Follow up with a clean, dry soft cloth.
• Avoid exposing furniture to extreme heat or cold; also avoid
wide humidity variance.
Laminate, Metal, Painted, and Polyurethane Surface
Care
• Clean 3D laminate surfaces with a mild soap and water
solution. Wipe dry with a soft, clean cloth.
3D Laminate Surface Care
• Clean as normal with a soft cloth and mild, non-alkaline
detergent using moderate pressure.
• Detergent must be free of silicone and other polishing
additives that may leave a residue causing streaks to form.
Abrasive and caustic cleaners are not be used.
• Excessive pressure or hard scrubbing motions may damage
the painted frost glass surface.
• Wipe glass surface until dry; liquids left on the glass may
cause staining.
Caring for Glass Surfaces
• These simple care guidelines provide tips on how to keep
your solid surface looking its best:
Caring for Corian Solid Surface
Care & Maintenance for Wilsonart Solid Surfaces
Caring for Solid Surfaces
• Expo dry erase markers are recommended for markerboard
and writable glass surfaces.
• All other markers are not recommended, as they may leave
undesirable results when erased.
• Permanent or non-dry erase markers should not be used.
• Dry erase erasers, not chalk board erasers should be used to
remove marker. Replace the erasers when heavily soiled.
• Clean surface with Expo markerboard cleaner. Residue from
other types of cleaners may cause markers to smear when
erased.
Markerboard and Writable Glass Surface Care
Cleaning and Care
www.kimball.com
Ensure the lasting beauty and performance of your wood furniture
with proper use and care.
• Clean surfaces with a water dampened soft cloth; always
wipe with the grain and dry the surface completely.
• If needed, clean with a small amount of non-alkaline dish soap
in warm water.
• Immediately remove any liquids from the furniture surface
with a blotting action.
• Lift objects to remove them; never pull them across the
surface.
• For an additional safeguard, use a protective desk pad. The
single item could ensure a lasting finish by protecting your
furniture from possible damage caused by pens or sharp
objects.
• If using a protective glass top, place spacer pads under the
glass to allow the wood to breathe.
• Avoid exposing furniture to extreme heat or cold; also avoid
wide humidity variance.
• Avoid exposure of furniture to strong sunlight. Prolonged
exposure may change the color of wood beneath the finish.
• Wood finishes can withstand cleaning solutions that include
bleach (10%), hydrogen peroxide (Virox), alcohol (CaviWipes,
hand sanitizers), quaternary ammonium compounds (Virex,
Ecolab A-456 II, Lysol) and phenols (Wex-cide) when they are
used in accordance with the manufacturer’s label instructions.
Cleaning Codes
• (W) Use water-based cleaning solutions (Resolve
™
Upholstery
Cleaner, or mix 2 tbsp of ammonia or ammoniated detergent,
such as Ajax
®
liquid, to 1 qt of water). Blot the stain gently with
a cloth dampened in this solution. Continue turning the cloth
to always use a clean portion.