Installation & Assembly

ManualsBrandsKimberly-Clark ManualsFacilities & MaintenanceProfessional Coreless JRT Paper Towel Dispenser

SCOTT

Coreless JRT

Loading Instructions

TO INSTALL DISPENSER

USING BRACKET AND

MOUNTING SCREWS

1 Determine at what height the

dispenser will be hung on wall. K-C

recommends positioning the bracket

36" from the floor and 12" from the

front edge of the toilet. Make sure

bracket remains level.

2 Using a pencil or other marker,

mark a dot on the wall where the

screw holes are on the bracket.

3 Attach the bracket to the wall

using the screws provided.

4 Line up the slots on the back of

the dispenser with the tabs on the

bracket. Push down firmly, making

sure the dispenser is fully seated

on the bracket.

5 While dispenser is hanging on wall

bracket, mark bottom two anchor

locations. Pre-drill the bottom

holes using a #25 drill bit.

6 Reposition dispenser on wall

bracket. Attach bottom of dis-

penser to the wall, installing

remaining two screws at bottom

left and right of dispenser back.

SEE OTHER SIDE FOR LOADING INSTRUCTIONS.

1 For best results, clean all surfaces

with alcohol before installation.

2 Remove backing from one

side

of each pad to expose adhesive.

Stick four adhesive pads on back

(smooth side) of wall plate, spacing

them evenly near corners of wall

plate. Apply bead of commercial

adhesive generously on back of

plate (not included with plate.)

3 Remove second paper covering

on each pad to expose adhesive.

Reverse wall plate and position it

on wall. Make sure the four bolts

are protruding and the two closer

together are at the top. Press firmly

to adhere plate to wall.

4 Line up the holes in the mounting

bracket with the top pair of bolts.

Place a nut on each screw and

tighten (turning clockwise) to

secure bracket on wall plate.

5 Find two horizontal slots on the

back of the dispenser unit. Align

these slots carefully with the two

horizontal tabs on the bracket.

Push firmly to lock the dispenser

securely onto the bracket.

6 Remaining pair of bolts should show

through the holes at the bottom of

the dispenser just inside the mouth.

Place a nut on each of these bolts

and turn clockwise to tighten.

7 Wait 24 hours before loading

dispenser; this allows adhesive to

cure thoroughly for better adhesion.

TO INSTALL DISPENSER

USING METAL WALL PLATE

Installing the dispenser

Summary of content (2 pages)

PAGE 1
SCOTT® Coreless JRT® Loading Instructions Installing the dispenser TO INSTALL DISPENSER USING BRACKET AND MOUNTING SCREWS 1 Determine at what height the dispenser will be hung on wall. K-C recommends positioning the bracket 36" from the floor and 12" from the front edge of the toilet. Make sure bracket remains level. 2 Using a pencil or other marker, mark a dot on the wall where the screw holes are on the bracket. 3 Attach the bracket to the wall using the screws provided.
PAGE 2
LOADING IS EASY — FRONT COVER DOES NOT OPEN! Inserting roll into dispenser 1 Install new roll by aligning “dimple” in center of tissue roll with left arrow located on the lower left of the dispenser front. With tissue unrolling in clockwise direction, push roll upwards firmly until it snaps into place. Removing main roll Inserting stub roll 4 Flip leftover roll so that tail unrolls in a counter-clockwise direction. Push the used roll up into the small space to the right and secure in the roll holders.