Installation & Assembly

® Registered Trademark of Kimberly-Clark Worldwide, Inc.

1 Install new roll by aligning

“dimple” in center of tissue roll

with left arrow located on the

lower left of the dispenser front.

With tissue unrolling in clockwise

direction, push roll upwards firmly

until it snaps

into place.

2 When roll is installed properly,

approximately 1" of tissue is

exposed and roll rotates freely.

3 When the tissue roll is no longer

visable through the viewing window,

the roll may be transferred to the

stub roll holder. To remove main

roll, slip hand upward between

back side of the roll and the front

side of the metal spring. Depress

the metal spring slightly and

dislodge the roll. Pull down

easily to remove.

4 Flip leftover roll so that tail unrolls

in a counter-clockwise direction.

Push the used roll up into the small

space to the right and secure in the

roll holders.

5 Refer to Step 1 to install new roll.

6 Tear off or rewind leading edge

of new tissue so that the end is

not showing.

SEE OTHER SIDE FOR MOUNTING INSTRUCTIONS.

LOADING IS EASY

—

FRONT COVER DOES NOT OPEN!

Inserting roll into dispenser Removing main roll Inserting stub roll