User's Manual

10
SPECIFICATIONS
•
•
•
•
3.9 Intended Use
This manual describes the setup and use of the Kinexon X-Tag. Use this product only for the purpose it was
designed for.
3.10 FCC Compliance
This device complies with 47 CFR Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment. This device may not be employed for the operation of toys. Operation onboard an aircraft, a ship or a
satellite is prohibited. The use of this device mounted on outdoor structures, e.g., on the outside of a building or on
a telephone pole, or any fixed outdoors infrastructure is prohibited.
Moreover, the following statements apply:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
3.11 FCC Caution
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This device is designed not to exceed the limits for exposure to radio waves
adopted by the FCC. These limits include a substantial safety margin design to assure the safety of all persons,
regardless of age and health. The radio wave exposure guidelines use a unit of measurement known as the Specific
Absorption Rate (SAR). SAR levels have been computed for the transmitters in this device and have been found to
be below FCC limits.
3.12 ISED Caution
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
These devices are not permitted for operation on board aircraft or satellites and shall also not be used for
operating toys. The use this device mounted on a fixed outdoor infrastructure, including antennas mounted on
outdoor structures such as poles or buildings, is not permitted, except for operation on board ships or land vehicles.
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation,
Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes:
(1) Cet appareil ne doit pas causer d'interférences
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un
fonctionnement indésirable de l'appareil.