Use and Care Manual

8) Now that all the ball straps are attached.
Insert the leg pipe into each plastic foot
pad.
9) Begin to attach the legs to the frame.
Place each leg next to the three and
four way ttings. Starting with the two
outside legs grab the base of the 3-way
corner tting. Lift the frame and insert
the Leg into the 3-Way tting. Next insert
the center legs.
10) Repeat step on other side until the
entire unit is standing upright.
11) Pull down and attach the leg skirt
straps to the foot pads at each corner.
Next attach the valance straps by clipping
the plastic hook to the open grommet
hole located on the cover’s valance
(4 total). Hook the plastic ring around the
foot pad and tighten.
LEG ASSEMBLY
Insert First
Insert First
Insert Second