Manual

ManualsBrandsKing Electric ManualsAccessories for electricalDS-824

LIMITED WARRANTY

The DS-824 is warranted against defects in workmanship and materials for two years from date of sale.

This warranty does not apply to damage resulting from accident, misuse, or alteration nor where connected

voltage is more than 10% above the configured operating voltage, nor to equipment improperly installed or

wired or maintained in violation of this Owner’s Manual. No other written or oral warranty applies. No

employee, agent, dealer or other person is authorized to give any warranties on behalf of ASE.

The customer shall be responsible for all costs incurred in the removal or reinstallation and shipping of the

product for repairs. Within the limitations of this warranty, inoperative units should be returned, freight

prepaid, to ASE, and we will repair or replace, at our option, at no charge to you with return freight paid by

ASE. It is agreed that such repair or replacement is the exclusive remedy available from ASE and that ASE

IS NOT RESPONSIBLE FOR DAMAGES OF ANY KIND, INCLUDING INCIDENTAL AND

CONSEQUENTIAL DAMAGE. Some states do not allow the exclusion or limitation of incidental or

consequential damages so the above exclusion may not apply to you. The warranty gives you specific legal

rights, and you may also have other rights which vary from state to state.

AUTOMATED SYSTEMS ENGINEERING, INC.

2519 E SAINT VRAIN ST

COLORADO SPRINGS, COLORADO 80909

PHONE: 719-599-7477 FAX: 719-599-7482

Visit us on the Internet at: www.goase.com

CAUTION: Read all instructions carefully before installation.

Save this Installation Manual for future reference.

DS-824

RAIN/SNOW SENSOR CONTROLLER

INSTALLATION MANUAL

STANDBY/RESET

NOT FOR HIGH VOLTAGE CONTROL

22−28V AC/DC 500 mA 50/60 Hz

30 A 24V AC, 20 A 24V DC

CONTROL

INPUT

CONTROL SWITCH

CAUTION

AUTOMATIC

MANUAL ON

DS−824

SYSTEMS

AUTOMATED

ENGINEERING

RAIN/SNOW SENSOR CONTROLLER

ENCLOSURE TYPE 3R

OFF

INDICATOR

TRIPON

Manufactured By

AUTOMATED

SYSTEMS

ENGINEERING

2519 East Saint Vrain St Colorado Springs, Colorado 80909

Summary of content (4 pages)

PAGE 1
LIMITED WARRANTY The DS-824 is warranted against defects in workmanship and materials for two years from date of sale. This warranty does not apply to damage resulting from accident, misuse, or alteration nor where connected voltage is more than 10% above the configured operating voltage, nor to equipment improperly installed or wired or maintained in violation of this Owner’s Manual. No other written or oral warranty applies.
PAGE 2
General Safety Instructions 1. THIS UNIT SHOULD BE INSTALLED, OPENED, AND REPAIRED BY QUALIFIED PERSONNEL ONLY! 2. To avoid shock hazard do not open the front cover with power connected to the DS-824 or any controlled equipment. 3. Limit input voltage to 22-28 VAC/VDC. 4. Replace fuse F1 with a 2 Amp 32 V or 250 V 3AG fast acting fuse ONLY. Moisture Sensor Mounting & Termination The remote DS-824 precipitation/moisture sensor may be mounted in a number of ways depending on the application.
PAGE 3
Fine Adjustment for Efficient Operation The DS-824 is shipped with the TEMP and DEL adjustments in the center position, representing 39°F (3.9°C) and 30 minutes of Delay-Off time respectively. The Sensitivity control is set for highest sensitivity. Depending on local conditions the user may find that fine adjustment of the controls may provide more satisfactory operation. If the sensor does not trigger during very wet snows the trigger temperature may need to be adjusted higher.
PAGE 4
in "controller" mode (DEL on) the Delay Off time can be adjusted from 30-90 minutes (LD Off) or 2-6 hours (LD On) using the “Delay Adjust” control. Note the “Forced Manual On” function at the low end of the Delay Adjust control. The relay will close when this area is entered and open when exited. Only use the “Forced Manual On” function for testing. Never leave the Delay Adjust control near the “Forced Manual On” area during normal operation.