Owner's manual

Installation
Mount sensor securely in upright position in clear (open) area typical of area to be melted, either above roof line or removed from
building as to not be protected from the falling snow.
AVOID overhead trees, shrubs, wires, eaves, etc., and following or blowing debris.
AVOID vehicle and foot traffic. Do not create a safety hazard.
AVOID exposure to artificial heat sources and excessive shock and vibration.
Install per all applicable electrical and building codes and regulations.
We Manage Heat ®
®
Model LCD
®
–7A Snow Switch
®
Part Number 21035
Installation Manual
Conduit body (or weatherproof box)
and rigid conduit supplied by user.
Make all threaded joints weathertight.
Ambient air temperature sensor.
Cool This Area Per Instructions When Testing
Insulate splices with wire nuts.
Grade or mounting
support surface.
1/2" NPT Galvanized Nipple.
Customer Supplied
Mount rigidly in upright postition
as shown above ground as
necessary to discourage animal
damage and vandalism.
0.75"
(19.1 mm)
Moisture sensing grid.
Windshield with
water drain slots.
2.00"
(50.8 mm)
2.25"
(57.2 mm)
2.65"
(67.3 mm)
3.86"
(98.1 mm)
3.86"
(98.1 mm)