Owner manual

Rev 9.15.12
www.king-electric.com 5
17
Crimp with the un-insulated connector.
18
Trim off excess braid.
19
Slide the 1/2” dia. X 1” heat shrink tube over the un-
insulated ground crimp. Apply heat evenly for
approximately 3 minutes to shrink the tube.
20
Immediately after shrinking, pinch the end of the tube
with flat nose pliers for approximately 10 seconds until
the end stays sealed.
21 22
Twist the bus wires together, make sure not to cross
the wires as this will cause a direct short, keep the left
side wires and right side wires separate. Slide the
insulated crimps onto the bus wires.
Fold the crimped braid back against the heating
cables. Wrap the black cloth tape evenly around crimp
and heating cables. Cover crimp completely.