Instructions / Assembly

BATTERY INSTALLATION

The timer requires two “AAA” alkaline batteries (not included) for operation.

Follow the below instructions for proper installation.

1. Always disconnect regulator from the propane tank before installing or removing batteries.

2. Locate battery cover on timer. Press and slide battery cover off as shown.

3. Install two “AAA” alkaline batteries. Match positive (+) and negative (-) symbols located on the case

and batteries to insure proper installation.

4. Replace the battery cover.

5. If the red “Low Battery” light becomes lit during use the batteries need to be replaced. Repeat the

above steps to remove and replace batteries.

BATTERY WARNINGS AND CAUTIONS

1. Always read and follow the battery manufacturer’s instructions.

2. Keep batteries away from small children. If battery is swallowed consult a physician immediately.

3. Do not dispose of batteries in a fire. Dispose of batteries safely, following guidelines for your area.

4. Install batteries correctly according to the “Battery Installation” directions above. Improperly

installed batteries may result in leaks and/or possible explosion.

5. Remove batteries from product after each use.

NOTE: Batteries which are not removed from this device will eventually corrode and leak and may

cause the timer to malfunction. If the batteries were not removed and/or if the unit has been

stored outdoors, test the timer for proper operation. Follow instruction number 4 on page 24

of this manual, with the cylinder valve closed. The green light (steady for 10 minutes and

blinking for a further 5 minutes) will then go off showing that the timer is operating properly

and you may proceed to use the cooker in accordance to the warnings and instructions in

this manual.

FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS COULD RESULT IN

FIRE, EXPLOSION, BURN HAZARD OR CARBON MONOXIDE POISONING WHICH

COULD CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.