Instructions / Assembly

LIGHTING AND OPERATING INSTRUCTIONS

THE COOKER MUST NOT BE LIT UNTIL THE PRECEDING

PLACEMENT INSTRUCTIONS HAVE BEEN COMPLETELY FOLLOWED.

FOR MODELS WITH ADJUSTABLE REGULATORS

1. Check the casting to make sure it is set up as per the illustration (Figure 1).

2. Make certain that the regulator control is turned to OFF by turning it counterclockwise until it reaches the stop.

3. Open cylinder control valve by turning it counterclockwise as per the diagram (Figure 2).

4. Insert a multipurpose lighter through the hole in the shroud as per Figure 4, or use a paper book match placed

above the casting as per Figure 5. Turn the regulator control toward the “ON” position until ignition occurs. Turning

the regulator control clockwise increases the gas pressure to the burner and hence the flame size (Figure 2).

When lighting the stove, if ignition does not occur in 3 to 5 seconds, turn the regulator and cylinder valve off. Wait

5 minutes for gas to disperse. Repeat procedure.

5. Check that the flame is blue and that the flames are emitted from every port in the casting. If not, rotate the air

shutter position until there is a blue flame. Opening the shutter too much will cause the flame to “Lift” off the burner

(Figure 6). If there is a yellow flame, or if some ports have no flame, this indicates there may be an obstruction in

the venturi tube or ports. Check the maintenance instructions on page 24 for more information regarding a yellow

flame.

6. Always monitor the flame throughout the cooking process. If at any point in the cooking process the flame is

accidentally extinguished, immediately turn the regulator and cylinder valve OFF. Wait 5 minutes for gas to disperse

and relight the cooker according to the lighting instructions (#1-#5) in this section.

NEVER PUT HANDS OR FACE DIRECTLY OVER BURNER WHILE LIGHTING OR

WHILE THE APPLIANCE IS LIT.

.61m

Air Shutter

Turn triangle handle

toward ON

(Counterclockwise)

Turn triangle handle

toward ON

(Counterclockwise)

Turn T-handle

toward ON

(Clockwise)

Turn T-handle

toward ON

(Counterclockwise)

24”