Product Manual

12
KKDFF30T / 8005 / 82-82TKD ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
ADJUSTABLE WRENCH
1. Place top half of unit on bottom half of unit as pictured.
2. Insert four bolts through holes in top and bottom of unit.
Wrench tighten with supplied lock washers and nuts.
3. Attach each wheel to the bottom half of the unit as pictured
using the supplied axels, lock washers and nuts.
4. Attach the cylinder heat plate onto the crossbar as pictured
using two bolts. Wrench tighten with supplied lock washers and nuts.
5. Insert threaded ends of cylinder collar
into crossbar as pictured.
Wrench tighten with supplied lock
washers and nuts.
6. Attach the tank ring to the bottom half of
the unit as per diagram using the U clips
which are welded to the outside of the
frame.
7. Refer to Figure 4, page 11 for hose
assembly instructions.
8. Go to the Use and Care section of this
manual for further instructions.
1/4 x 1”
Bolt
Lock
Washer
Nut
Top Half
Cylinder Collar
Cross
Bar
Heat
Plate
Wheel/Axle
Tank
Ring
Bottom Half
2620, 2621 AND 2654
ASSEMBLY INSTRUCTIONS
1) Assemble bolts, washers and nuts as per diagram.
2) Wrench tighten. Make sure all bolt sets are used
and unit stands sturdily.
3) Go to pg. 9 for casting installation instructions.
4) Refer to Figure 1, page 10 for hose
assembly instructions.
CONTENTS
(1) Bottom Ring
(3) Legs
(1) Shroud with Welded Top Ring
(1) Casting/Air Shutter
(1) Hose/Regulator
(3) Foot Extensions
(12) Bolts, Lockwashers and Nuts
TOOLS NEEDED
Adjustable Wrench
Screwdriver
1
2
3
Legs bolt to outside of bottom ring
(3 bolts, nuts and lockwashers).
Legs bolt to outside of shroud
(6 bolts, nuts, and lockwashers).
Foot extensions bolt to outside of
bottom ring (3 bolts, nuts and
lockwashers).
* Model May Vary From Picture
Leg
Bottom Ring
Shroud
with Welded
Top Ring
Foot Extension