Use and Care Manual

1803PKP Work Table Assembly Instructions

Cooker

Frame

Work Table

1) Place edge of work table into U-clip receivers

on cooker frame to attach the work table

assembly to the cooker. See Picture.

2) Go to the Use and Care Section of this

manual for further information.

CS01 Assembly Instructions

REQUIRED TOOLS: Adjustable Wrench

CS01 Parts List:

(1)Top Frame

(1)Casting/Air Shutter

(1)LP Hose/Regulator

(1)Thermometer

(4)Leg

(1)Bottom Shelf

(2)Side Work Shelf

(2)Support Bracket wtih U Clips

1) Review the contents in your package. Make sure all listed components for your model are included.

2) Go to pg. 9 for casting installation instructions.

3) Install the four legs into the top frame by matching the numbers on the legs to the numbers on the leg receivers (for

example: 1 to 1, 2 to 2, etc...) Snap in leg bolts through receiving holes on frame. Make sure the leg bolts pop

completely out and legs are locked in position.

4) Install bottom shelf into shelf clips on legs.

5) Hang side work shelves onto top frame using the U clips welded to frame. Attach support brackets to side work

shelves and bottom shelf as per diagram by fitting the U clip of one end of support bracket to bottom of side shelf

and the other end to the side of bottom shelf as pictured above.

6) Refer to Figure 1 pg. 10 for hose assembly instructions. Then go to the Use and Care Section of this manual for

further instructions.

FRY BASKET HANDLE ASSEMBLY

Required Tools: Adjustable Wrench and Screwdriver

Attach handle by inserting bolts (round head to inside of pan) into holes indicated in

black. Apply nuts and tighten.

2. Some models of baskets have a 4 bolt “square” design for assembly. Attach handle

by inserting bolts through supplied holes on basket and handle (round head of bolt

to inside of pan.) Apply nuts and tighten.

* Model May Vary

From Picture

Insert Bolts in marks as instructed