Installation Guide

11
13. Install the smoker front door to the "right" side wall using the provided bracket pins/receivers located on outside
of wall. See Figure 2, page 9.
14. Install cabinet thermometer on front smoker door. Remove nut from stem of thermometer and
insert stem through the front of the smoker door in hole provided. Reattach nut to thermometer stem
on inside of door to tighten. See Figure 2, page 9 for proper thermometer placement.
15. Locate the drip cup and hanger. Install the drip cup to the bottom of the smoker cabinet by inserting
the hanger through the holes provided. See below Figure 7 for proper drip cup placement.
16. Go to the Use and Care Section of this manual for further instructions.
8. Turn smoker right side up. Make sure smoker stands sturdily.
9. Install cool grip side handles on both sides of smoker using eight black bolts (4 on each handle). Bolts should
thread towards inside of smoker. See Figure 2, page 9.
10. Locate the cool grip door handle. Remove the two bolts that are pre-attached to the extensions of the handle.
Align the two extensions of the cool grip door handle to the two holes provided on the outside of the smoker
door. Re-attach the two bolts to the extensions of the cool grip door handle from the inside of the smoker door.
Tighten. See Figure 2, page 9.
11. Install the two side dampers onto smoker cabinet using two black bolts (one bolt on each damper).
Bolts should thread toward inside of smoker. See Figure 2, page 9.
12. Install the rear damper onto the back of the smoker cabinet using one black bolt. Bolt should thread toward
inside of smoker. See Figure 6.
Figure 6
Figure 7