Instructions / Assembly

BRASS FITTING WITH MANUAL VALVE

ASSEMBLY INSTRUCTIONS

Locate the brass fitting with manual valve (with hose/regulator attached). Tighten the brass fitting’s

threaded end (with orifice) into the venturi with a torque wrench, up to a torque of 95 to 105 lb./in.

Alternatively, hand tighten securely and then, using a wrench, tighten an additional 1-1 1/2 turns.

The manual valve handle should be positioned upright when installed. See below for pictures of

correct assembly.

Check that the 3/8” female flare swivel end of the hose is fully tightened onto the brass fitting

with an adjustable wrench. The hose to valve connection, as well as all other gas joints, must be

tightened and leak tested (see Leak Test instructions on page 13) before using the appliance.

Brass Fitting

Manual Valve

Venturi

Orifice

LP Gas Hose

Carefully arrange the lava rock evenly on top of the burner and in the bowl. Do not pour or drop lava rocks

onto the burner or bowl as damage could occur to burner ports or bowl.Placement of lava rocks may

need to be adjusted to produce a more realistic looking flame. Arrange lava rocks as needed to produce

a flame that extends upward and toward the center above the appliance. After operation of the appliance,

ALWAYS allow time for the lava rocks to cool completely before removing or adjusting lava rocks. NEVER

attempt to move lava rocks while the appliance is lit or still hot.

LAVA ROCK INSTRUCTIONS

3/8 Female

Flare Swivel