Instructions / Assembly
25
9090 LIGHTING AND OPERATING INSTRUCTIONS
THE COOKER MUST NOT BE LIT UNTIL THE PRECEDING
PLACEMENT INSTRUCTIONS HAVE BEEN COMPLETELY FOLLOWED.
Pot must be installed onto cooker frame and filled with water before lighting appliance.
The lid support rod must be in straight or angled position before lighting appliance.
(Figure 2).
3. Figure 1
EVER ATTEMPT TO LIGHT IN ANOTHER LOCATION OTHER THAN
THE LIGHTING HOLES.
Attach the
EACH
Figure 3 or Figure 4Make sure each jet pipe is properly lit. Turning
(Figure 2).
Figure 5 for proper flame emission.
4. Always monitor the flames throughout the cooking process. If at any point in the cooking process the flames are
NEVER PUT HANDS OR FACE DIRECTLY OVER BURNER WHILE LIGHTING
OR WHILE THE APPLIANCE IS LIT.
FIGURE 1
FIGURE 3
Lighting Holes
Jet Pipes
FIGURE 4
FIGURE 5
Multipurpose
Lighter
Lighting
Rod
and Match
Jet Pipe
Note - The above picture
shows an example of
a properly lit jet pipe.
Model 9090 has two jet
pipes. Both jet pipes
must be lit.
.61m
24
20LB. LP
GAS
CYLINDER
Jet Pipe
Jet Pipe
Turn Cylinder Handle
toward ON
(Counterclockwise)
Next
Turn Regulator Control
toward ON
(Clockwise)
ADJUSTABLE REGULATOR
FIGURE 2
20LB. LP
GAS
CYLINDER