User's Manual

PREPARTION

 Never operate the tractor and tiller until you have read and completely under-

stand this manual, the Tractor Operator’s Manual, and each of the safety mes-

sages found on the safety signs on the tractor and tiller.

 Personal protection equipment including hardhat, safety glasses, safety shoes, and gloves

are recommended during assembly, installation, operation, adjustment, maintenance, re-

pairing, removal, or moving the implement. Do not allow long hair, loose fitting clothing, or

jewelry to be around equipment.

 PROLONGED EXPOSURE TO LOUD NOISE MAY CAUSE PERMANENT HEARING

LOSS! Tractors with or without tillers attached can often be noisy enough to cause perma-

nent, partial hearing loss. We recommend that you wear hearing protection on a full-time

basis if the noise in the operator’s position exceeds 80 db. Noise over 80 db on a long-

term basis can cause severe hearing loss. Noise over 90 db adjacent to the operator over

a long-term basis may cause permanent, total hearing loss. NOTE: Hearing loss from loud

noise (from tractors, chain saws, radios, and other such sources close to the ear) is cumu-

lative over a lifetime without hope of natural recovery.

 Operate the tiller only with a tractor equipped with an approved Roll-Over-Protective Sys-

tem (ROPS). Always wear your seat belt. Serious injury or even death could result from

falling off the tractor — particularly during a turnover when the operator could be pinned

under the ROPS or the tractor.

 Clear area to be tilled of stones, branches or other debris that might be thrown or entan-

gled in the tiller, causing injury or damage.

 Operate only in daylight or good artificial light.

 Ensure tiller is properly mounted, adjusted and in good operating condition.

 Ensure that all safety shielding and safety signs are properly installed and in good condi-

tion.

STARTING AND STOPPING SAFETY

 Check the tractor master shield over the PTO stub shaft. Make sure it is in good condition

and fastened securely to the tractor. Purchase a new shield if old shield is damaged or

missing.

 All tractors that are not equipped with a “live” power takeoff (PTO) need to be equipped

with an over-running PTO clutch. These are available through most farm equipment

stores. NOTE: The addition of an over-running PTO clutch may change the length of the

PTO driveline required. Pay extra attention to the instructions on the PTO Driveline Instal-

lation. Be sure that the driveline system guarding is adequate.

 Tiller operating power is supplied from the tractor PTO. Refer to your tractor manual for

PTO engagement and disengagement instructions. Know how to stop tractor and tiller

quickly in case of an emergency.

 When engaging PTO, the engine RPM should always be at idle speed. Once engaged and

ready to start tilling, raise PTO speed to 540-RPM and maintain throughout tilling opera-

tion.