Product Manual

OPERATING INSTRUCTIONS
CUTTING HEIGHT ADJUSTMENT
To prevent blades from striking the ground your rotary should be set to the highest
position that will give desired grass height. By setting your mower up this way you
reduce blade wear and stress on the mower. Mowing at regular intervals will yield
far better results than periodic mowing. (i.e. weekly vs. by-weekly mowing.)
STEP 1
Raise rotary mower off the ground with the tractor and SECURELY BLOCK IN
POSITION.
STEP 2
Remove pin from top of wheel fork assembly. Lower wheel fork assembly from
tail wheel arm.
STEP 3
Arrange spacers until desired cutting height is achieved. Cutting heights range
from approximately 2.0-6.0 inches in height.
STEP4
Reinstall wheel fork assembly into tail wheel arm and install keeper pin.
STEP 5
Repeat adjustment process on remaining wheel fork assembly. NOTE: make
sure all are adjusted to the same height for an even cut.
STEP 6
Check to ensure that tail wheel does not come with in the specified 1" for the
rear deck. See Figure D on page 12.
20