Use and Care Guide

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Preparing for mounting

□ Route the wires exiting the top of the fan motor assembly (E)

through the decorative motor collar cover (D) and then the

center of the canopy bottom cover (FF).

□ Make sure the opening of the canopy (C) is on top and insert

the ball/downrod (B) through the canopy (C).

□ Route the wires exiting the top of the fan motor assembly (E)

through the downrod as shown.

□ Pull off the canopy bottom cover (FF) from the canopy (C).

□ Loosen the two canopy screws (GG) located in the

bottom of the mounting bracket (A), and turn the canopy

counterclockwise to remove the mounting bracket (A)

from canopy (C).

NOTE: The magnet is pre-attached on the canopy bottom

cover (D) for you to remove and install easily.

Installing the blades

□ Attach a blade (F) to the fan-motor assembly (E) by

inserting the blade (F) into the slots in the side of the fan

motor housing and aligning the three screw holes in the

blade with the holes in the center ywheel and secure

with screws (AA).

□ Make sure all the screws are rmly tightened.

□ Repeat these steps for the remaining blades.