User's Manual

Assembly - Standard Ceiling Mount

Routing the wiresPreparation for standard mounting

Ƒ Route the wires exiting at the top of the fan-motor

assembly (E) through the canopy ring (HH).

Ƒ Insert the ball/downrod (B) through the canopy (C) and

slide the decorative motor collar cover (D) onto the end

of the ball/downrod (B). Make sure the slots on the

canopy (C) are on top.

Ƒ Route the wires exiting the top of the fan motor

assembly (E) through the downrod as shown.

Ƒ Remove the canopy ring (HH) from the canopy (C) by turning

the ring counterclockwise until it unlocks.

Ƒ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (FF) located in the “L

shaped” slots.

Ƒ Remove and save the two canopy screws (GG) in the round

holes. This will enable you to remove the mounting bracket

(A).

Assembling the fan

Ƒ Loosen, but do not remove, the setscrew (JJ) on the collar

on top of the fan-motor assembly (E).

Ƒ Install the downrod (B) by inserting it into the motor collar

(KK), and turning it clockwise until it is tight.

Ƒ Reinstall the setscrew (JJ) turning clockwise until tight.

NOTE: This fan is equipped with a safety tab (II). Should

the setscrew (JJ) ever become loose while the fan is

running in reverse, the safety tab (II) will engage and stop

the fan from falling.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the downrod (B) and the setscrew

(JJ) must be completely tightened.