User's Manual

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wiresPreparation for standard mounting

Ƒ Route the wires exiting at the top of the fan-motor

assembly (E) through the canopy ring (FF).

Ƒ Insert the ball/downrod (B) through the canopy (C) and

slide the decorative motor collar cover (D) onto the end

of the ball/downrod (B). Make sure the slots on the

canopy (C) are on top.

Ƒ Route the wires exiting the top of the fan motor

assembly (E) through the downrod as shown.

Ƒ Remove the canopy ring (FF) from the canopy (C) by turning

the ring counterclockwise until it unlocks.

Ƒ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (DD) located in the “L

shaped” slots.

Ƒ Remove and save the two canopy screws (EE) in the round

holes. This will enable you to remove the mounting bracket

(A).

Assembling the fan

Ƒ Loosen, but do not remove, the setscrew (GG) on the collar

(II) on top of the fan-motor assembly (E).

Ƒ Install the downrod (B) by inserting it into the motor collar

(II), and turning it clockwise until it is tight.

Ƒ Re-tighten the setscrew (GG) on the collar (II) on top of the

fan motor assembly (E).

NOTE: This fan is equipped with a safety tab (HH). Should

the setscrew (GG) ever become loose while the fan is

running in reverse, the safety tab (HH) will engage and

stop the fan from falling.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the downrod (B) and the setscrew

(GG) must be completely tightened.