User's Manual

4. Loosen, but do not remove, the set
screws on the collar on the top of the
motor housing.
5. Align the holes at the bottom of the
downrod with the holes in the collar
on top of the motor housing (Figure 9).
Carefully insert the bolt through the
holes in the collar and downrod. Be care-
ful not to jam the bolt against the wir-
ing inside the downrod. Insert the
clevis pin through the hole near the end
of the hanger pin until it snaps into its
locked position, as noted in the circle inset
of Figure 9.
6. Re-tighten the set screws on the collar on top
of the motor housing.
5.
FAILURE TO PROPERLY INSTALL LOCKING PIN
AS NOTED IN STEP 5 COULD RESULT IN THE
FAN LOOSENING AND POSSIBLY FALLING.
Figure 10
Screws
And Rubber
Washers
Sockets
Bulbs
Reversing
Switch
3. Route the wires exiting the top of the fan
motor through the decorative glass housing.
Then route the wires through the canopy
ring and then the canopy. Continue by rout-
ing the wires through the ball/downrod as-
sembly (Figure 9).
Pin in
Position
Locked
Canopy
Motor Wires
Ring
Canopy
Decorative
Housing
Glass
Hanger Pin
Tighten
Screws
Motor Collar
Locking
Pin
Downrod/Ball
Assembly
Figure 9
Installing the Top
Glass Housing
The glass housing is fragile, use care
when installing the fan.
1. Remove the two screws and rubber wash-
ers pre-installed on the top of the fan motor
assembly.
2. Carefully place the decorative glass housing
onto the fan motor assembly (Figure 10).
3. Align the two screw holes in the decorative
glass housing with the screw holes on the
top of the fan motor assembly and securing
with the screws and washers that were re-
moved in step 1.
4. Install 4 candelabra base bulbs (Max. 15
watts, provided) to the sockets on the fan
motor assembly.
120V Wires
Ceiling
Mounting
Plate
UL Listed
Outlet Box
Slide Mounting
Plate Over
Screw Heads
Hook
Mounting Screws
(Supplied with
Outlet Box)