User's Manual

7.
Figure 11
WHITE
BLACK
BLUE
BLACK
WHITE
WHITE
Outlet
Box
Grounding
Green
Lead
Ground
to
Downrod
SUPPLY CIRCUIT
Receiver
WHITE
RED
WHITE
BLACK
BLUE
WHITE
BLACK
BLUE
Finishing the Fan
Installation
1. Align the four screw holes in the canopy
with the four screw holes in the mounting
plate.
2. Secure the canopy in place by using the four
mounting screws that were removed in step
2 as described on page 4.
3. You may now proceed to install the decora-
tive support rods.
Installing the Light
Kit/ Glass Shade
REMEMBER to disconnect the power.
THE GLASS IS FRAGILE, USE CARE
WHEN INSTALLING THE LIGHT KIT AND
THE GLASS SHADE.
1. Remove the three mounting screws on the
light kit switch cup.
2. Connect the wires exiting the light kit brack-
et below the fan motor with the wires from
the light kit switch cup, black to blue and
white to white (Figure 12).
3. Carefully push all the wires into the light kit
switch cup.
NOTE: ALLOW THE BULBS TO COOL
COMPLETELY BEFORE TOUCHING OR
REPLACING THE BULBS TO AVOID ACCI-
DENTAL BURNING OF THE SKIN.
DO NOT OVERTIGHTEN THE FINIAL,
OVERTIGHTENING THE FINIAL MAY
CAUSE THE GLASS TO BREAK.
4. Slide the light kit switch cup and secure it to
the light kit bracket using the three screws
removed in step 1.
5. Remove the nial, hex nut and rubber wash-
er on the bottom of the light kit assembly.
6. With the power off, insert the light bulbs
into the light kit sockets, Max. 60 watt can-
delabra base bulbs provided.
7. Raise the glass shade up against the light
plate of the fan motor assembly. Place the
rubber washer and then the hex nut removed
in step 5. Firmly tighten the hex nut to hold
the glass bowl in place (Figure 12).
8. Re-install and nger tighten the nial.
OVER LAMPING THE FAN WILL RESULT IN
THE FAN LIGHTS SHUTTING DOWN UNTIL THE
PROPER WATTAGE OF BULBS ARE INSTALLED.
RESET THE LIGHTS BY TURNING OFF, RE-
PLACE BULBS WITH THE CORRECT WATTAGE
BULBS, TURN POWER ON.