Manualshelf

User's Manual

ManualsBrandsKing of Fans ManualsElectronics52 Inch Mormont
78910111213141516
12
Assembly - Attaching the Blades
Attaching the fan blades
1
□ Attach a blade (F) to the fan-motor housing (E) by inserting the
blade (F) into slots in the side of the fan motor housing (E) and
aligning the three screws holes in the blade with the holes in
the center ywheel and secure with screws (AA).
□ Make sure all the screws are rmly tightened.
□ Repeat these steps for the remaining blades.
Assembly - Hanging the Fan (continued)
Mounting the fan-motor assembly
(standard mount)
□ Align the locking slots of the ceiling canopy (C) with the two
screws (EE) in the mounting bracket (A). Push up to engage
the slots and turn clockwise to lock in place.
□ Firmly tighten the two mounting screws (EE).
□ Install the two mounting screws (FF) (saved from Assembly
Step 1 “Preparation for standard mounting”) into the holes in
the canopy (C) and tighten rmly.
□ Install the decorative canopy ring (GG) by aligning the ring’s
slots with the screws in the canopy (C). Rotate the ring
counter-clockwise to lock in place.
7a
WARNING: When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
E
AA
F
E
C
A
GG
EE
Mounting the fan-motor assembly
(close-to-ceiling mount)
□ Align the locking slots of the ceiling canopy (C) with the two
screws (EE) in the mounting bracket (A). Push up to engage
the slots and turn clockwise to lock in place.
□ Firmly tighten the two mounting screws (EE).
□ Install the two mounting screws (FF) (saved from assembly
Step 1 “Preparing for mounting”) into the holes in the
canopy (C) and tightened rmly.
□ Install the decorative canopy ring (GG) by aligning the ring’s
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
7b
WARNING: The locking slots of the ceiling canopy are
provided only as an aid to mounting. Do not leave the fan
assembly unattended until all four canopy screws are engage
and rmly tightened.
E
C
A
GG
EE