User's Manual

Installing the bulbs and the light kit decorative cage

□ Remove the nial (QQ) from the light kit tter assembly (K).

□ With power off, install the three Edison bulbs (L)(Max.40W,

included) by screwing into the light bulb sockets.

□ Push the light kit decorative cage (J) up to the light kit

plate, make sure the tubs of the light kit decorative cage(J)

are properly located into the notch on the light kit plate.

□ Hold the light kit decorative cage (J) using one hand,

position the bottom cap (M) over the threaded nipple,

make sure the tubs of the light kit decorative cage (J) are

properly located into the notch on the bottom cap.

□ Re-install the nial (QQ) to the threaded nipple to secure

the light kit decorative cage.

WARNING: Over lamping the light kit will result in the lights

shutting down until the proper wattage of bulbs are installed.

Reset the lights by turning off the lights, replacing the bulbs

withe the correct wattage bulbs, and turn the lights back on.

Assembly - Attaching the Light (continued)

Attaching the light kit plate

□ Remove one screw (PP) from the light kit pan (F), and loosen,

but do not remove the other two screws.

□ Push the light kit plate (G) up to the light kit pan so the two

loosened screw heads t into the keyholes slots. Turn the

light kit plate (G) clockwise to secure.

□ Re-install the screw (PP) that was removed in step 1.

□ Make sure all the screws are rmly tightened.

Assembly - Attaching the Light (continued)