User's Manual

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

Ƒ Remove the canopy ring (FF) from the canopy (C) by turning

the ring counter-clockwise until it unlocks.

Ƒ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (JJ) located in the “L

shaped” slots.

Ƒ Remove and save the two canopy screws (II) in the round

holes. This will enable you to remove the mounting bracket

(A).

Ƒ Route the wires exiting the top of the fan motor (D) into

the decorative motor collar cover (F) and through the

canopy ring (FF).

Ƒ Make sure the slot openings are on top and route the

wires through the canopy (C) and then through the ball/

downrod assembly (B).

Ƒ Remove the setscrew (DD) by turning it counterclockwise.

Ƒ Install the downrod (B) by inserting it into the motor collar (M),

and turning it clockwise until it is tight.

Ƒ Reinstall the setscrew (DD) turning clockwise until tight.

NOTE: This fan is equipped with a safety tab (EE). Should

the setscrew (DD) ever become loose while the fan is

running in reverse, the safety tab (EE) will engage and

stop the fan from falling.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the downrod (B) and the setscrew

(DD) must be completely tightened