Specification

120V

Figure 1

Figure 2

CABLE SELECTION GUIDE

NOTE: For pipe diameter 3/8” to 3/4” only, cable can be up to 2 ft. shorter than pipe length.

LENGTH OF PIPE

3/8"-3/4" 3' 4-5' 6' 7-8' 9' 10-11' 12' 13-14' 15' 16-17' 18' 19-20' 21-23' 24' 25’-27' 28-29' 30' 40’ 60‘ 80’

(9.53-19.05mm) 0.9m 1.2-1.5m 1.8m 2.1-2.4m 2.7m 3-3.4m 3.7m 4-4.3m 4.6m 4.9-5.2m 5.5m 5.8-6.1m 6.4-7m 7.3m 7.6-8.2m 8.5-8.8m 9.1m 12.2m 18.3m 24.4

Select Cable Length (ft.) 3' 3' 6' 6' 9' 9' 12' 12' 15' 15' 18' 18' (2pcs) 12' 24' 24' (2pcs) 15' 30’ 40’ 60’ 80’

LENGTH OF PIPE

1"-1 1/2" 3' 4-5' 6' 7-8' 9' 10-11' 12' 13-14' 15' 16-17' 18' 19-20' 21-23' 24' 25-27' 28-29' 30' 40’ 60‘ 80’

(25.4-38.1mm) 0.9m 1.2-1.5m 1.8m 2.1-2.4m 2.7m 3-3.4m 3.7m 4-4.3m 4.6m 4.9-5.2m 5.5m 5.8-6.1m 6.4-7m 7.3m 7.6-8.2m 8.5-8.8m 9.1m 12.2m 18.3m 24.4

Select Cable Length (ft.) 3' (2pcs) 3' 6'

(1pc) 3'

9' (2pcs) 6' 12'

(1pc) 6'

15' (2pcs) 9' 18'

(1pc) 9'

(2pcs) 12' 24'

(1pc) 12'

(2pcs) 15' 30' 40’ 60’ 80’

& (1pc) 6' & (1pc) 9'

& (1pc) 12'

& (1pc) 15'

Cable length is determined as follows:

For Pipe 3/4” or less in diameter: Round pipe length down to the nearest 3-foot increment. Cable can be up to 2 feet shorter than pipe.

For Pipe 1” to 1-1/2” in diameter: Cable can not be run shorter than pipe length. Overrun should not exceed 3 feet.

*When using 2 cables, install on opposite sides of the pipe (as shown)

**Overrun in the middle of the pipe should not exceed 3 feet

**Should not exceed 3 feet

Note: Pipe must be wrapped with 1/2” minimum thickness ﬁberglass insulation

Constant Wattage Pipe Trace Cable