Use and Care Manual

MAINTENANCE & WARRANTY

#$-%".."%#/$(#-%+0'%#/$-

KCV SERIES Cove

Heater

It is extremely important to verify the electrical power supply is the same voltage as the heater being installed. 240

nd 120 Volt heaters are not interchangeable. Powering a 240 Volt unit with 120 Volt supply wires will reduce heater

output by approximately 75%. Powering a 120 Volt unit with 240 Volt supply wires will destroy the heater and voids all

guarantees and warranties.

CAUTION: Turn off power source supplying heater before attempting any installation, maintenance or repairs.

Lock or tag circuit breaker/fuse panel door. Failure to do so could result in serious electrical shock, burns or

possible death.

WARNINGS: To insure proper operation of this heater it should be a minimum of 6 feet above the ﬂoor and no closer

than 2½" below drywall ceiling (6" vinyl or drop ceilings). Draperies should clear the front and top of this heater by

6". Draperies hung below the heater should have a 2 1/2" clearance. Do not block the heater in any manner. Never paint

the heater.

Sectional heaters are completely assembled and pre-wired. To prepare the heater for installation, carefully check the

voltage to be used is the same as stated on the rating nameplate. Operating voltage can not exceed 5% of nameplate

voltage. Operating heater above listed voltage ratings voids all guarantees and warranties.

SAVE THESE INSTRUCTIONS

GENERAL INFORMATION

KING ELECTRICAL MFG. COMPANY • 9131 10TH AVENUE SOUTH • SEATTLE, WA 98108 • PH: 206.762.0400 • FAX: 206.763.7738 • www.king-electric.com

Following the guidelines herein listed will result in a maintenance-free heater. There are no moving parts or motors

to maintain. Periodic dusting of the front panel is all that is suggested.

The KCV Cove Heater carries a one (1) year warranty from date of installation. Please refer to the manufacturer’s

warranty statement for further information.

REV. 66447_8-30-16

PAGE 1
#$-%".."%#/$(#-%+0'%#/$- KCV SERIES Cove Heater It is extremely important to verify the electrical power supply is the same voltage as the heater being installed. 240 and 120 Volt heaters are not interchangeable. Powering a 240 Volt unit with 120 Volt supply wires will reduce heater output by approximately 75%. Powering a 120 Volt unit with 240 Volt supply wires will destroy the heater and voids all guarantees and warranties.
PAGE 2
#$-%".."%#/$(#$-%+0'%#/$- Following are some general guidelines: • Do not recess this cove heater. • Disconnect power at main panel. • Make certain all wiring is in accordance with all local codes and units are properly grounded. • Voltage rating of heater should be the same as supply load. • WIRING DIAGRAM SINGLE POLE BLACK HEATER Do not install the heater on vinyl wall coverings. GROUND INSTALLATION 1. Remove heater from carton. Disassemble the aluminum heating panel from the back support frame.