Use and Care Manual

Portable Baseboard
Installation Instructions
ELECTRIC SHOCK OR FIRE HAZARD
DANGER
!
!
WARNING
!
!
Read Carefully - These instructions are written to help you prevent difficulties that might arise during usage
of this portable Heater. Studying the instructions first may save you considerable time and money later. Ob-
serve the following instructions Save these instructions.
Models Covered
KP1205 27 inch 500 Watts 120 Volt
KP1207 36 inch 750 Watts 120 Volt
KP1210 48 inch 1000 Watts 120 Volt
KPH1215 36 inch 1000 Watts 120 Volt
IMPORTANT INSTRUCTION: SAVE THESE INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock,
and injury to persons, including the following:
1. Read all instructions before using this heater.
2. Use this heater only as described in this manual. Any other use not recommended by the manufacturer and may
cause fire, electric shock, or injury to person. Do not leave this heater in unoccupied areas or with unsupervised
children.
3. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or re-locatable power
tap (outlet/power strip). Extension cords can melt and cause a fire.
4. Connect to properly grounded outlets only. Check outlet for heat with indicates replacement is needed.
5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or
damaged in any manner. Discard heater or return to an authorized service facility for examination, and/or repair.
6. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route
cord under fu
rniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
Never coil cord up when operating, doing this generates enough heat to melt the cord.
7. Always unplug heater when not in use.
8. To disconnect heater, turn controls to off, then remove plug from outlet.
9. A heater has hot and arching or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable
liquids are used or stored. Keep out of areas of wood flour or high dust. Blow out element yearly.
10. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handle when moving
this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes, and curtains away
from heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a
bed, where baseboard intake openings may become blocked.
12. Do not insert or allow foreign objects to enter any inlet or exhaust opening as this may cause an electric shock or
fire, or damage the heater.
13. This heater is not intended for use in wet areas like bathrooms, laundry areas and similar indoor locations. Never
locate heater where it may fall into a bathtub or other water container.
14. Never run more than one heater on a receptacle or circuit.
15. Clean Heater surfaces with mild soap and water. Strong cleaners will ruin the finish.
* SAVE THESE INSTRUCTIONS *
Fig. 1
Made in USA. Seattle Washington

Summary of content (4 pages)