User Manual
Operation
Antenna Setup
Connections
Not for in-motion use!
Magnetic base may be
temporarily mounted to any
magnetic surface.
Use rubber base cover to
protect surface.
Set up and make connections as shown below.
1
Perform a channel scan with your digital tuner or digital TV.
2
Watch TV. Enjoy!
3
KING OmniGo Antenna
To Power Injector
Tighten (2) Thumb Screws
Tighten (2) Thumb Screws
Magnetic Base
Protective Rubber
Base Cover
(Truck not included)
11200 Hampshire Ave S, Bloomington MN 55438
PH 952.922.6889 FAX 952.922.8424
www.kingconnect.com 22544 Rev A ©2016
KING OmniGo is a trademark of Electronic Controlled Systems, Inc.
KING is a registered trademark of Electronic Controlled Systems, Inc.
(3) Coax Retaining Clips
Tripod
To Power Injector
12V DC Auxiliary
Power Cord
Power Supply
25’ Coax Cable
Power Injector
AC
TV
(not included)
Do not connect power injector in opposite direction.
Incorrect connections may damage equipment.
!
OR
!
● Do not put antenna/tripod where it can be bumped, knocked over or struck by a person or vehicle.
● Do not put near any heat sources.
● Do not route coax where it can be tripped on or run over by a vehicle.
● Do not overtighten coax connections.
● Do not put sharp bends or kinks in coax cable.