User Guide

Page 2
POLE MUST BE STATIONARY:
NOT ON A VEHICLE.
This is a directional antenna
and should be rotated on the
pole to the position that provides
maximum signal reception.
Option 1: BAT WING STYLE REPLACEMENT
1. Turn off antenna power injector at wall switch or A/V switch and raise the existing antenna.
2. Attach the RV antenna bracket to the KING Jack antenna with the 4 supplied screws.
3. Unscrew coax cable and remove existing bat wing style antenna (if present) from the retractable arm (keep retaining pins and
clips). Line up holes in RV antenna bracket with holes in retractable arm and reinsert pins thru assembly. Reinstall retaining
clips (use new supplied retaining clips if necessary). You must mount antenna in relation to poles as shown below.
4. Fill end of existing coax cable with supplied dielectric grease and screw to antenna (DO NOT OVERTIGHTEN).
Note: If existing coax connector is corroded or damaged, replace with supplied new connector.
If installing new coax cable (sold separately), connect as stated, and then route properly thru retractable arm and into vehicle.
Make appropriate connections in vehicle.
Option 2: POLE MOUNT BRACKET
1. Attach the L-shaped bracket to the KING Jack antenna with the 4 supplied screws.
2. Remove 2 existing screws and 2 existing washers from L-shaped bracket. Attach pole clamp to the L-shaped bracket with the
same screws and washers.
3. Place the clamp around an appropriate pole and tighten wing nuts.
4. Fill end of coax cable (sold separately) with supplied dielectric grease and screw to antenna (DO NOT OVERTIGHTEN).
Note: If replacing an existing antenna and the existing coax connector is corroded or damaged, replace with supplied new
connector. Route coax cable and make appropriate connections.
5. Position antenna for maximum signal reception and tighten wing nuts to secure the antenna in this position.
IMPORTANT! Make sure to
mount head in relation to pole
heights as shown.
This will allow poles to fully
retract to stowed position.