User Manual

Page 19
6. Run coax from the antenna unit to the roof edge, then along edge to location where it will be
fed into the vehicle. Secure coax to roof every 12-18 inches (see below).
7. Drill 3/4” hole through the roof and into the cabinet where receiver is stored. Feed coax down
through hole. Seal opening with roof compatible sealant so that it is completely waterproof
(inside and outside of the 3/4” hole).
8. Inside vehicle, connect coax cable to the receiver.
9. Go to DISH TAILGATER OPERATION Section.
IMPORTANT!
Roof hole for wiring must be sealed so
it is completely waterproof.
Sealant must be roof compatible.
The CE2000 Cable Entry
Cover provides a water
tight seal where cables
penetrate the roof. See
www.kingconnect/products/
accessories/ for more
information.
IMPORTANT!
You can cut the coax
to length but you must
terminate the coax with
Snap-n-Seal Connectors.