User Manual

Page 5
The DISH Tailgater requires an unobstructed view of the southern sky for signal reception. Be sure
to place the DISH Tailgater in a location free from obstructions such as trees, buildings, etc. (See
page 3.) Point the handle approximately north to speed up search time.
1. Connect one end of the supplied RG-6 coax cable to the MAIN port on the DISH Tailgater and
place in position. It is recommended you use only the supplied RG-6 coax cable.
2. Connect the other end of the supplied coax cable to the SATELLITE IN port on your receiver.
3. Plug your receiver into a 110 volt AC power source.
The green power light on your receiver should illuminate or begin cycling on and off.
Wait for the green light to turn solid.
This may take up to two minutes.
If it does not turn solid, power on your receiver using
the front panel POWER button. (On “z” models,
this is located behind the door panel.)
4. Plug in and turn on your TV.
In your TV’s input selection menu, choose the input that matches the connection from your
receiver. (Example: If using an HDMI cable from your receiver, choose the HDMI input on your
TV.) See your TV owner’s manual for details.
DISH TAILGATER SETUP
• Do not put the DISH Tailgater where it can be bumped, knocked over or struck by a person or vehicle.
• Do not put the DISH Tailgater near any heat sources.
• Do not route the coax cable where it can be tripped on or run over by a vehicle.
• Do not over tighten the coax cable connections.
• Do not put sharp bends or kinks in the coax cable.
NOTE: Place the DISH Tailgater on a stable and reasonably level surface with a clear view of the southern sky.
When placing the DISH Tailgater in position, be sure surface is dry and free of loose dirt or sand.
Front of ViP
®
211z receiver with door open
HAND TIGHTEN COAX. OVER TIGHTENING CAN DAMAGE CONNECTIONS.