Datasheet

SPEC NO: KDA0114 REV NO: V.1 DATE: SEP/07/2001 PAGE: 1 OF 4

APPROVED: J.Lu CHECKED: DRAWN: S. H. CHEN

Description

The Super Bright Orange source color devices

are made with DH InGaAlP on GaAs substrate

Light Emitting Diode.

3.2x1.6mm SMD CHIP LED LAMP

KP-3216SEC SUPER BRIGHT ORANGE

Notes:

1. All dimensions are in millimeters (inches).

2. Tolerance is ±0.2(0.0079") unless otherwise noted.

3. Lead spacing is measured where the lead emerge package.

4. Specifications are subject to change without notice.

Features

!3.2mmx1.6mm SMT LED, 1.1mm THICKNESS.

!LOW POWER CONSUMPTION.

!WIDE VIEWING ANGLE.

!IDEAL FOR BACKLIGHT AND INDICATOR.

!VARIOUS COLORS AND LENS TYPES AVAILABLE.

!PACKAGE : 2000PCS / REEL.

Package Dimensions

Digitally signed by YANGSHOUFEN

cn=YANGSHOUFEN, ou=KINGBRIHGT, o=42, c=US

Date: 2002.02.23 16:35:56 +08'00'

Reason: Document is certified

PAGE 1
3.2x1.6mm SMD CHIP LED LAMP KP-3216SEC SUPER BRIGHT ORANGE Features Description !3.2mmx1.6mm SMT LED, 1.1mm THICKNESS. The Super Bright Orange source color devices !LOW POWER CONSUMPTION. are made with DH InGaAlP on GaAs substrate !WIDE VIEWING ANGLE. Light Emitting Diode. !IDEAL FOR BACKLIGHT AND INDICATOR. ! VARIOUS COLORS AND LENS TYPES AVAILABLE. !PACKAGE : 2000PCS / REEL. Package Dimensions Digitally signed by YANGSHOUFEN cn=YANGSHOUFEN, ou=KINGBRIHGT, o=42, c=US Date: 2002.02.
PAGE 2
Selection Guide Par t No . Dic e KP-3216SEC Iv (m c d ) @ 20 m A L en s Ty p e SUPER BRIGHT ORANGE( InGaAlP ) WATER CLEAR V i ew i n g An g l e Min . Ty p . 2θ1/2 40 20 0 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at T)=25°°C Sy m b o l Par am et er D ev i c e Ty p . λpeak Peak Wavelength Super Bright Orange λD Dominate Wavelength ∆λ1/2 Max .
PAGE 3
Super Bright Orange KP-3216SEC SPEC NO: KDA0114 APPROVED: J.Lu REV NO: V.1 CHECKED: DATE: SEP/07/2001 DRAWN: S. H.
PAGE 4
KP-3216SEC SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: KDA0114 APPROVED: J.Lu REV NO: V.1 CHECKED: DATE: SEP/07/2001 DRAWN: S. H.