WARNING This product can expose you to chemicals including carbon monoxide which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
(Top: 32 in Side: 26 in)
Not Provided M5X8 -6-
Hardware Used: 4x Bolts and Nuts (pre-assembled) 1.Attach wheels (10) to bottom plate (1) . Hardware Used: 3x Bolts and Nuts (pre-assembled to Brackets) 2.Locate the propane cylinder bracket (11) and attach it on the bottom plate with 3 bolts and nuts provided with the bracket.Use the M8x45 screw to secure the propane cylinder. Hardware Used: 12x Screws Hardware Used: 20x Screws 3.Connect and fix the 4 lower support (6) to the bottom plate(1) and middle plate (3) with screws (19). 4.
Hardware Used: 1x AA Battery Hardware Used: 1x Rubber Ring 4x Screws 5.Unscrew the red igniter button on the control box and insert the AA battery (17) with the POSITIVE end facing upward.Then attach the control box (2) underneath the middle plate (3) with screws (19). 6.Carefully put the glass tube (7) up through the center of the hole in the upper plate (4).Make sure the rubber ring (18) is attached on the lower end of the glass tube. Now place the glass tube through the hole on the middle plate (3).
Hardware Used: 3x Studs 3x Wing Nuts 7. Attach the bolts onto the damper (4),and put 3pcs washer onto the bolts,then put the reflector (8) onto the bolts,put 3pcs washer through the bolts and fix with screws Hardware Used: 4x Screws 8.Attach the protection guards (9) to the upper frame by inserting the hooks at the top of the guards into the holes on the supports. Repeat at the bottom of the supports. Secure the protection guards to the top of the supports with the fixing brackets(12) and screw in place.
Ti p: d
PREPARATI ON:
AA battery is missing or dead Replace AA battery
