Installation Manual

Kingfisher Company, inc. STAR-ELT Manual
KCi #99420-MAN Rev 0.6 Page 19 of 29
Figure 11 STAR-ELT Main Board Primary Controls
14.1 System Reset Button
Initiates reset of the interface board. The Yellow Power Trouble LED flashes the firmware
version number after this button is pushed.
14.2 Test Signal
Press the Test / Program button SW1 for 3 seconds to transmit a test message. Power troubles on
the STAR-ELT will be transmitted after the test signal transmits if applicable. Test / Program
led will illuminate Yellow.
14.3 Tamper Function
The STAR-ELT contains an integral optical tamper sensor that continuously monitors the state
of the cabinet door. When the door is opened, the STAR-ELT will automatically transmit a
Tamper signal to the receiving station. This feature can be enabled or disabled via
programming.
SW1 Test /
Program Switch
U18 Optical
Tamper Switch
SW2 System
Reset