Installation Manual

Kingfisher Company, inc. STAR-ELT Manual
KCi #99420-MAN Rev 0.6 Page 24 of 29
18. STAR-ELT Transmitter Programming
The STAR-ELT supports an integral Bluetooth interface for programming. The KCi Wireless
Programming App must be installed on either an iOS handheld device, Android handheld device,
or Windows 10 laptop. Pressing the Test / Program button SW1 on the STAR-ELT and holding
it in for 3 seconds will activate the Bluetooth interface and allow the programming app to
connect.
Programming functions via the app include
- Setting the box number
- Setting the number of function digits
- Setting the transmitter frequency
- Setting the test time and interval
- Sending a test message and measuring antenna health
- Setting the time and date
- Zone disconnect / bypass and re-enable
Press the PROGRAM button until the adjacent LED turns RED. This will place the unit in
programming mode and allow you to connect using the iOS or Android programming app.
When the Radio Transmitter is in Program mode it is not able to function as an alarm transmitter.
In case the Program button is pushed accidently or Program mode is not exited, a timer in the
transmitter automatically exits from Program mode and returns the transmitter to normal use if
there is no activity for 30 seconds. Be aware that this may also occur before programming is
complete and it will be necessary to reenter program mode before saving the updated parameters
to the transmitter.
The basic programming sequence is
➢ Connect to the device
➢ Download parameters
➢ Modify parameters
➢ Upload to the device
Parameter Download:
Open the Kingfisher Cordless Programmer app (iOS or Android), select the Bluetooth device
associated with the STAR-ELT, enter the programming password, and download system
parameters.
Parameter Modification :
Modify parameters in the “Parameters” tab according to the following table
Programming Complete
In the Upload / Download tab, select “Upload” to send the new parameters to the device.